Apatite fission track analysis of Upper Jurassic Houcheng Formation at Qianjiadian area,Beijing and its geological significance

LI Jian-Feng,TANG Wen-Hao,LIU Zhao,ZHANG Zhi-Cheng
DOI: https://doi.org/10.3969/j.issn.0001-5733.2010.12.014
2010-01-01
Abstract:Apatite fission track analysis is made to reconstruct the tectonic-thermal history of Jurassic basin at Qianjiadian area, Beijing. AFT ages of the three samples located at upper Houcheng Formation are concentrated in 85. 7 similar to 76.0 Ma, smaller than corresponding stratigraphic age; the mean confined track length is 9.4 similar to 10.8 mu m, smaller than the initial confined track length (16.3 +/- 0.9 mu m), showing a single peak state of skewed length distribution, and the standard deviation is 2.1 similar to 2.5; AFT ages of the three samples located at lower Houcheng Formation are concentrated in 82.6 similar to 62.4 Ma, also smaller than corresponding stratigraphic age; the mean confined track length is only 7.2 similar to 7.7 mu m, far shorter than the initial track length (16.3 +/- 0.9 mu m), where the length of the mean confined track of YQ-07 shows proximal bimodal distribution, with the standard deviation of 3.1. Clearly, these six samples experienced moderate annealing, and the maximum temperature may be close to 90 degrees C. The regularity of AFT ages and the mean confined track length was mainly caused by the temperature difference due to changes in depth. Fission track thermal history modelling results show that the basin sediments reached the maximum depth of more than 3000 meters, and the basin temperature reached maximum of more than 90 degrees since sediments filling into the basin until about 115Ma, with deposition rate of about 66.7 m/Ma during the process. After 115 Ma the basin was in a relatively stable period, and there was no significant temperature fluctuation until late Miocene. The temperature suddenly dropped with a rate around 11.7 degrees C/Ma in about 6 Ma, and the Jurassic sediments were exhumated rapidly to the surface, with denudation rates of more than 500 m/Ma.
What problem does this paper attempt to address?