Abstract:A novel chemically-modified electrode and electrochemical method for the determination of isoniazid were reported. Compared with the bare glassy carbon electrode (GCE), multi-wall carbon nanotube (MWNT)-modified GCE can greatly enhance the oxidation peak current of isoniazid. The electrochemical behaviors of isoniazid in various medium such as pH 5.0 similar to 8.0 phosphate buffer, pH 3.5 similar to 5.6 NaAc-HAc buffer, pH 8.0 similar to 11.0 NH3-NH4Cl buffer, pH 1.8 similar to 12.0 Britton-Robinson buffer (each 0.1 mol/L), were compared. It is found that the oxidation response of isoniazid is best in pH = 5.0 B-R buffer since the peak current is highest and the peak shape is best-defined. The influence of the amount of MWNT-DHP suspension on the oxidation peak current of isoniazid was also examined. The oxidation peak current increases significantly by increasing the MWNT-DHP suspension from 0 to 6 mu L, and then increases slightly from 6 to 10 mu L and finally decreases. Thus, the amount of 1 g/L MWNT-DHP suspension is chosen as 8 mu L in this work. Additionally, the effect of scan rate on the oxidation peak current of isonizid was tested by linear sweep voltammograms (LSV). The oxidation peak current, in the range of 0.025 similar to 0.3 V/s, had a good linear relationship with scan rate, indicating that the oxidation of isoniazid at the MWNT-modified GCE is an adsorption-controlled process. The oxidation peak current increases greatly within the first 60 s and then levels off. Therefore, 60 s accumulation, was used to improve sensitivity and shorten sample analysis. After that, a sensitive and rapid electrochemical method was developed for the determination of isoniazid. The oxidation peak current changes linearly with the concentration of isoniazid over the range from 4 x 10(-7) to 5 X 10(-5) mol/L. The detection limit is about 1.5 x 10(-7) mol/L for 60 s accumulation. The relative standard deviation was 4.9% for 5 x 10(-6) mol/L isoniazid (n = 10). Finally, this method was successfully employed to determine isoniazid in isoniazid tablets and blood serum.

Voltammetric Determination of Pyridoxine (vitamin B6) by Use of a Chemically-Modified Glassy Carbon Electrode.

Electrochemical Behavior and Determination of VB6 at Carbon Nanotube Modified Electrode

Voltammetric Determination of Pyridoxine in Pharmaceutical Samples Using Phosphorus-Doped Copper Oxide Pencil Graphite Electrode

Voltammetric Determination of Vitamin B6 at Glassy Carbon Electrode Modified with Gold Nanoparticles and Multi-Walled Carbon Nanotubes

A surface-modified graphene – carbon-based composite sensor for the voltammetric assessment of pyridoxine in food and pharmaceutical samples

Electrochemical Detection of Pyridoxal Using a Sonoelectrochemical Prepared Highly-Oxidized Carbon Nanosheets Modified Electrode

Electrochemical determination of vitamin B6 (pyridoxine) by reformed carbon paste electrode with iron oxide nanoparticles

Electrochemical sensing of vitamin B6 (pyridoxine) by adapted carbon paste electrode

Determination of Vitamin B 6 (pyridoxine Hydrochloride) Based on a Novel BZ Oscillating Reaction System Catalyzed by a Macrocyclic Complex

A Novel Two-Dimensional Liquid Chromatography Combined with Ultraviolet Detection Method for Quantitative Determination of Pyridoxal 5′-Phosphate, 4-Pyridoxine Acid and Pyridoxal in Animal Plasma

Electrochemical Behavior And Determination Of Isoniazid At Multi-Wall Carbon Nanotube Modified Electrode

ELECTROCHEMICAL BEHAVIOR OF VITAMIN B6 ELECTROCHEMICALLY ACTIVATED GLASSY CARBON ELECTRODE

Voltammetric Determination of Dopamine in the Presence of Ascorbic-Acid at Over-Oxidized Polypyrrole Indigo Carmine Film-Coated Electrodes

Preparation of a Glassy Carbon Electrode Modified with Reduced Graphene Oxide and Overoxidized Electropolymerized Polypyrrole, and Its Application to the Determination of Dopamine in the Presence of Ascorbic Acid and Uric Acid.

Voltammetric Determination of Theophylline at a Nafion/multi-wall Carbon Nanotubes Composite Film-Modified Glassy Carbon Electrode

Electrochemical sensing of vitamin B 6 using platinum nanoparticles decorated poly(2-aminothiazole)

Platinum Nanoparticles Decorated Multiwalled Carbon Nanotubes – Ionic Liquid Composite Film Coated Glassy Carbon Electrodes for Sensitive Determination of Theophylline

New voltammetric method for determination of tyrosine in foodstuffs using an oxygen-functionalized multi-walled carbon nanotubes modified acetylene black paste electrode

Determination of Vitamine B_6 by Poly(L-Glutamic Acid) Modified Electrode with Flow-injection Irreversible Biamperometry

Determination of Ascorbic Acid in Pharmaceuticals and Food Supplements with the New Potassium Ferrocyanide-Doped Polypyrrole-Modified Platinum Electrode Sensor

A Novel Electrochemical Sensor for Probing Doxepin Created on a Glassy Carbon Electrode Modified with Poly(4-Amino- Benzoic Acid)/Multi-Walled Carbon Nanotubes Composite Film