Abstract:Presented in this study is investigation of dynamic behavior of a helical gear reduction by experimental and numerical methods. A closed-loop test rig is designed to measure vibrations of the example system, and the basic principle as well as relevant signal processing method is introduced. A hybrid user-defined element model is established to predict relative vibration acceleration at the gear mesh in a direction normal to contact surfaces. The other two numerical models are also constructed by lumped mass method and contact FEM to compare with the previous model in terms of dynamic responses of the system. First, the experiment data demonstrate that the loaded transmission error calculated by LTCA method is generally acceptable and that the assumption ignoring the tooth backlash is valid under the conditions of large loads. Second, under the common operating conditions, the system vibrations obtained by the experimental and numerical methods primarily occur at the first fourth-order meshing frequencies and that the maximum vibration amplitude, for each method, appears on the fourth-order meshing frequency. Moreover, root-mean-square (RMS) value of the acceleration increases with the increasing loads. Finally, according to the comparison of the simulation results, the variation tendencies of the RMS value along with input rotational speed agree well and that the frequencies where the resonances occur keep coincident generally. With summaries of merit and demerit, application of each numerical method is suggested for dynamic analysis of cylindrical gear system, which aids designers for desirable dynamic behavior of the system and better solutions to engineering problems.

Axial Vibration Reduction Characteristics of a Gear System with a Damping Ring

Torsional Vibration Suppression of A Gear System Installed with A Damping Ring

Nonlinear Vibration Characteristics of Helical Bevel Gear Systemand Parameters Influences

Simulation of nonlinear vibration of automobile main reducer

Nonlinear Vibration Characteristics of Two-Stage Gear Reducer

An Internal Resonance Based Method for Reducing Torsional Vibration of a Gear System

Study on the Nonlinear Dynamic Behavior of Rattling Vibration in Gear Systems

Dynamic analysis of a helical gear reduction by experimental and numerical methods

Vibration characteristics analysis of face gear transmission system considering gyroscopic effect

Analysis on the vibration reduction for a new rigid–flexible gear transmission system

Vibration Analysis of the Double Row Planetary Gear System for an Electromechanical Energy Conversion System

Dynamic investigation and experimental validation of a gear transmission system with damping particles

Theoretical and Experimental Study on Non-Linear Vibration Characteristic of Gear Transmission System

Torsional Vibration Reduction Analysis of Variable Damping Torsional Vibration Damper for Engine Crankshaft

Analysis of Vibration Characteristics of Face Gear powering-split Transmission System

Dynamic modeling and analysis for a drive axle gear transmission system

Dynamic modeling of a gear transmission system containing damping particles using coupled multi-body dynamics and discrete element method

Gear Rattle Modeling Based on Transient Stiffness and Damping Analysis

Design and Analysis of a Dynamic Absorber for Reducing Axial Vibration of Ship Shafting

Effect of Particle Friction Coefficient on Vibration Reduction in Gear Transmission

Vibration Characteristics of Rotor System Considering Gear Meshing