Abstract:Warm deformation is a plastic-forming process that differs from traditional cold and hot forming techniques. At the macro level, it can effectively reduce the problem of high deformation resistance in cold deformation and improve the surface decarburization issues during the hot deformation process. Microscopically, it has significant advantages in controlling product structure, refining grain size, and enhancing product mechanical properties. The Gleeble-1500D thermal-mechanical physical simulation system was used to conduct isothermal compression tests on GCr15 bearing steel. The tests were conducted at temperatures of 600-1050 °C and strain rates of 0.01-5 s-1. Based on the experimental data, the critical strain model and dynamic recrystallization model for the warm-hot forming of GCr15 bearing steel were established in this paper. The model accuracy is evaluated using statistical indicators such as the correlation coefficient (R). The dynamic recrystallization model exhibits high predictive accuracy, as indicated by an R-value of 0.986. The established dynamic recrystallization model for GCr15 bearing steel was integrated into the Forge® 3.2 numerical simulation software through secondary program development to simulate the compression process of GCr15 warm-hot forming. The dynamic recrystallization fraction was analyzed in various deformation regions. The grain size of the severe deformation zone, small deformation zone, and difficult deformation zone was compared based on simulated compression specimens under the conditions of 1050 °C and 0.1 s-1 with the corresponding grain size obtained with measurement based on metallographic photos; the relative error between the two is 5.75%. This verifies the accuracy of the established dynamic recrystallization and critical strain models for warm-hot deformation of GCr15 bearing steel. These models provide a theoretical basis for the finite element method analysis and microstructure control of the warm-hot forming process in bearing races.

High Temperature Flow Stresses in C-grade Steel for Train Components

Research on Hot Forging Process of C-Grade Steel Train Wheel by Fem

Constitutive Analysis on High-Temperature Flow Behavior of 3Cr-1Si-1ni Ultra-High Strength Steel for Modeling of Flow Stress

Influence of hot compressive parameters on flow behaviour and microstructure evolution in a commercial medium carbon micro-alloyed spring steel

Constitutive modeling and analysis on high-temperature flow behavior of 25 steel

Analysis on the Key Parameters to Predict Flow Stress during Ausforming in a High-Carbon Bainitic Steel

Experimental investigation of cold-formed steel material at elevated temperatures

Finite Element Analysis of Dynamic Recrystallization Model and Microstructural Evolution for GCr15 Bearing Steel Warm-Hot Deformation Process

Hot Deformation Behavior and a Two-Stage Constitutive Model of 20mn5 Solid Steel Ingot During Hot Compression.

Plastic-deformation Properties of 21crmo10 at High Temperature

Microstructure Evolution and Flow Stress Model of a 20mn5 Hollow Steel Ingot During Hot Compression

Hot Deformation Behavior of New-Typed CHDG-A06 Austenitic Stainless Steel

Deformation Behavior and Constitutive Equation of 42CrMo Steel at High Temperature

Study on hot deformation behavior of as-cast 22%W high-density steel

Study on Flow Behavior and Processing Maps of High‐Ti Low‐C Microalloyed Steel during Hot Compression

Constitutive modeling of deformation in high temperature of a forging 6005A aluminum alloy

High temperature flow behavior and constitutive model of alloy transition layer in composite steel tube prepared by centrifugal self‐propagating high‐temperature synthesis (SHS)

A Coupled Electrical–Thermal–Mechanical Modeling of Gleeble Tensile Tests for Ultra-High-Strength (UHS) Steel at a High Temperature

Modeling flow stress and grain size of GCr15 bearing steel at high-temperature deformation near end of solidification

Study on dynamic recrystallization of ultra-high strength 22MnB5 steel during hot rolling

Hot Deformation Behavior and Recrystallization Analysis of Pipe 20CrNiMo Steel