Bow waves of a family of fine ruled ship hulls with rake and flare
F. Noblesse,G. Delhommeau,Chi Yang
2008-01-01
Abstract:Introduction A broad class of ship hulls, including the classical Wigley parabolic hull and the Series 60 ship model, have bows that resemble a wedge. This simple class of bows is characterized by only two parameters: the draft D and the waterline entrance angle2α, as shown in Fig.1. The bow wave due to such a wedgeshaped bow also depends on two parameters: the draft-based Froude number F = Vs/ √ gD , whereVs stands for the speed of the ship (assumed to steadily advance along a straight path in calm water of infinite depth and lateral extent) and g is the acceleration of gravity, and the waterline entrance angle 2α . The bow waves generated by the two-parameter family of wedged-shaped ship bows depicted in Fig.1 are considered in [1-3] where several simple relations are given. In particular, expressions that define the height of the bow wave, the distance between the ship stem and the crest of the wave, the rise of water at the stem, and the bow wave profile are given in these three previous studies. The comparisons between the analytical relations and experimental measurements reported in [1-4] show that, in spite of their remarkable simplicity, these relations are sufficiently accurate for practical design applications. However, the practical usefulness of these relations is restricted by the fact that the two-parameter family of ship bows shown in Fig.1 is inadequate for many applications. Indeed, many ship bows, notably bows of fast ships, have significant rake and flare. Rake and flare must then be taken into account to design a ship bow. The wave created by a ship bow with rake and flare is considered in [5]. There, thin-ship theory is used to extend the relations for the height of the bow wave and the distance between the ship stem and the wave crest previously obtained for wedge-shaped ship bows, and a parametric study of the variations of the bow-wave height and location with respect to the hull speed, draft, rake, and flare is reported. The thin-ship analysis given in [5] is applied further in [6] to systematically investigate the influence of the hull speed, draft, rake, and flare on the bow-wave profile, the rise of water at the hull stem, and the bow-wave length, not considered in [1-5]. The extensive (unpublished) parametric study presented in [6] (recently submitted) and [5] (in press) is briefly summarized here. Following [5], we consider a family of ruled ship bows defined by four parameters, as shown in Fig.2: the draft D of the ship bow, the entrance angle 2α at the top waterline (at the free surface), the rake angle δ (angle between the ship stem and the vertical) and the hull flare, controlled by α − α′. Here,2α′ is the entrance angle at the bottom waterline (at the ship draft). The parameter φ defined as