Effect of HMW-GS 6+8 and 1.5+10 on Wheat Quality Traits in Synthetic Hexaploid Wheat

TANG Yong-lu,YANG Wu-yun,TIAN Ji-chun,LI Jun,CHEN Fang
2008-01-01
Abstract:【Objective】This study was conducted to determine the effect of 6+8 and 1.5+10 HMW-GS on main quality parameters in synthetic hexaploid wheat. 【Method】A set of RILs derived from the cross between a synthetic hexaploid wheat with 6+8 and 1.5+10 HMW-GS and cultivar Chuanyu12-1 (CY12-1) with 1, 7+8, 2+12 was planted in three environments in 2005 and 2006. A total of 16 quality parameters were tested. 【Result】Significant difference between parents was observed for all quality parameters except flour yield. The mean values of the RILs were intermediate to the parents for grain and protein parameters and some Farinograph parameters (FWA, SOF), but beyond parents at DST, BRT, QN, NS, LOV. There was a significant difference among combinations of HMW-GS in all quality traits, especially in GH, SED, and most of Farinograph parameters. The difference between alleles at same locus was both influenced by quality parameter and other two loci. For most parameters tested, 6+8 was better than 7+8 while there was no difference between 1.5+10 and 2+12. End-use quality was greatly influenced by combinations of HMW-GS as the combination of 1, 6+8, 1.5+10 had the highest LOV and BS, and the combination of 1, 7+8 and 1.5+10 with the highest NS. NS displayed a positive linear relationship with FN and its relationships with other quality parameters were based on experimental environments. LOV had a significantly negative relationship with SOF and positive associations with most of qualityparameters. 【Conclusion】 HMW-GS 6+8 in synthetics showed better overall quality characteristics than 7+8. The effect of 1.5+10 on quality varies with quality parameters and combinations of HMW-GS. Synthetics with subunits 6+8 and 1.5+10 have potential application value in end-use quality improvement of common wheat.
What problem does this paper attempt to address?