Abstract:As wind turbines become larger and move into deeper sea, their operating environment worsen. The torque fluctuation inside the drive chain is aggravated, which leads to the premature failure of the wind turbines. To improve the transmission stability of wind turbines, the mechanical-hydraulic hybrid transmission system (MHHTS) has been applied. However, existing research has issues with structure and hydraulic control. An MHHTS structure was proposed to meet the requirements of structural simplicity and high efficiency, corresponding to the design principles summarized in the article. Based on this structure, we have selected a hydraulic control mode, the constant displacement pump variable displacement motor (CPVM), that satisfies the reasonable utilization of displacement and the stability of control. This mode was chosen by comparing the displacement and pressure variation rules of three hydraulic control modes that meet the maximum power point tracking (MPPT) control principle of the wind turbine. In this study a co-simulation model of a 10 MW MHHTS wind turbine was built using Simulink and AMEsim. The correctness of the structural and control mode ware verified by co-simulation with a uniformly varying wind. Moreover, a method that can suppress fluctuations in output power by controlling the motor displacement was proposed. Different-step winds response analyses were conducted to explore the relationship between the displacement response speed and the output power fluctuations. The non-linear relationship between the displacement and the wind speed can also have an impact on the previous relationship. Finally, the feasibility of the control method was verified through simulation of an actual turbulent wind. These achievements should guarantee the future application of the novel transmission system in wind turbines.

Application of Parallel Dual PWM Converter to the Low-speed Permanent Magnet Direct-driven Wind Turbine

Study of a Single-stage Three-phase PFC DC/DC Converter With Series-parallel Connected Transforms

Analysis and Comparison of Medium Voltage High Power DC/DC Converters for Offshore Wind Energy Systems

Unit Power Factor Control of Direct-Drive Permanent Magnet Wind Generator

Control Strategy for Direct-drive Wind Generation Grid Side Converter Based on Carrier Phase Shifting Parallel

Dual Stator Windings PMSG Fed by Half-Controlled Converters for Wind Power Application

Circuit-level Parallel Strategies of Three Phase PWM Converters Without Zero Sequence Circulating Current

The Research on Carrier Phase-shift SPWM and Circulating Currents in Parallel Converters

Improved Discontinuous Pulse Width Modulation Strategy for Wind Power Converters

Complementary half controlled converter for directly-driven PM synchronous generator in wind power generation application

Multi-switching Table Based Direct Power Control for the Grid-side Converter of Doubly Fed Induction Generator Wind Turbines

A Hybrid Push-Pull Converter with Series-Parallel Structure in the Primary Windings

A novel control strategy of wind turbine MPPT implementation for direct-drive PMSG wind generation imitation platform

Study of Converter System Topology for Direct-Driven Wind Generation System

Improved PWM Modulation Strategy for CHB Multilevel Converter

Design and Implementation of Wind Turbine Imitation System for Direct Drive Permanent Magnet Synchronous Generator Using DC Motor

Control Strategy of Cascaded Multilevel Converter Based on Dual Active Bridge for Wind Energy Conversion System.

Design and Control of the Mechanical-Hydraulic Hybrid Transmission System in Wind Turbines

Sensorless Control of Pmsg Based on Dual Two-Level Inverter Open Winding Configuration for Wind Turbines

Application of Modular Multilevel Converter in Medium Voltage High Power Permanent Magnet Synchronous Generator Wind Energy Conversion Systems

A Unidirectional Cascaded High-Power Wind Converter with Reduced Number of Active Devices