Calculation of Oxygen Isotope Fractionation in Anhydrous Silicate Minerals

YF ZHENG
DOI: https://doi.org/10.1016/0016-7037(93)90042-u
IF: 5
1993-01-01
Geochimica et Cosmochimica Acta
Abstract:Thermodynamic oxygen isotope factors for anhydrous silicate minerals have been calculated by means of the modified increment method. The obtained order of O-18 enrichment in common rock-forming minerals is quartz > albite greater-than-or-equal-to K-feldspar > sillimanite greater-than-or-equal-to leucite > andalusite > jadeite > kyanite > anorthite greater-than-or-equal-to cordierite > diopside > wollastonite > zircon almost-equal-to garnet > olivine.Two sets of self-consistent fractionation factors between quartz and the silicate minerals and between the silicate minerals and water have been respectively obtained for a temperature range of 0 to 1200-degrees-C. The present results on the quartz-mineral systems are in good agreement with high-temperature data derived from semi-empirical calibrations and calcite-exchange experiments, demonstrating that the present calculated fractionation factors for mineral pairs are applicable to isotopic geothermometry and as a test of disequilibrium in natural mineral assemblages over all temperature ranges of geological interest. The silicate-water fractionations obtained from the present calculations also match those from hydrothermal experiments (except 3-isotope exchange results). The present calculations provide a potential insight into the quantitative dependence of oxygen isotope fractionation upon chemical composition and structural state of minerals. Minerals may be depleted in O-18 with increasing pressure as a result of the change in crystal structures.
What problem does this paper attempt to address?