Crystal Orientation Changes In Two-Dimensionally Confined Nanocylinders In A Poly(Ethylene Oxide)-B-Polystyrene/Polystyrene Blend

ping y huang,Lei Zhu,Stephen Z. D. Cheng,Qing Ge,Roderic P. Quirk,Edwin L. Thomas,Bernard Lotz,Benjamin S. Hsiao,Lizhi Liu,Fengji Yeh
DOI: https://doi.org/10.1021/ma010671x
IF: 5.5
2001-01-01
Macromolecules
Abstract:A lamella-forming poly(ethylene oxide)-b-polystyrene (PEO-b-PS) diblock copolymer has been blended with a low molecular weight polystyrene (PS) homopolymer to form a miscible polymer blend. The PEO volume fraction is 0.32, and the order-disorder transition temperature (T-ODT) of this blend is 175 degreesC. Therefore, the PEO blocks form nanocylinders surrounded by a PS matrix below the TODT. Since the glass transition temperature of the PS is 64 degreesC and the PEO crystal melting occurs at similar to 50 degreesC, the PEO-block crystallization takes place in a two-dimensionally confined glassy environment. The cylinder diameter is determined to be 13.7 nm, based on small-angle X-ray scattering (SAXS) and transmission electron microscopy results. Using simultaneous two-dimensional SAXS and wide-angle X-ray scattering techniques, the crystal orientation (the c-axes of the PEO crystals) within the nanocylinders is found to change simply depending upon the crystallization temperature (T-c). At very low T-c (< -30 <degrees>C), PEO crystals are randomly oriented within the confined cylinders. Starting at T-c = -30 degreesC, the crystal orientation changes to be inclined with respect to the cylinder axis, (a) over cap. The tilt angle from (a) over cap continuously increases with increasing T-c, and finally it becomes 90 degrees when T-c greater than or equal to 2 degreesC. Crystallographic analysis indicates that the crystal c-axis orientation at each T-c corresponds to a uniform crystal orientation.
What problem does this paper attempt to address?