Abstract:The anisotropic and irreversible expansion properties of polymer‐bonded explosives (PBX) can significantly influence the utility and reliability of associated equipment. The physical state of PBX under temperature cycling affects the strain distribution across the surface of cylindrical specimens. This strain is indicative of the irreversible growth and anisotropic expansion of the specimens. In this study, fiber Bragg grating sensors are employed to monitor the strain of PBX throughout the temperature cycling process, and our focus was on analyzing the changes in anisotropy and strain distribution during the cycle. The relationships between strain, temperature, material properties, and differences among various materials are examined. Experimental results indicate that the strain along the height and radial directions of the PBX specimens displayed a monotonic gradient distribution, increasing progressively in areas of higher density. TATB‐based PBX exhibited anisotropic expansion throughout the temperature cycling, with the degree of anisotropy increasing during heating and decreasing upon cooling. Conversely, HMX‐based PBX showed greater expansion in the height direction during both the heating and cooling phases, but it did not display noticeable anisotropy following the temperature cycling. At the highest temperature‐holding stage (100°C), the HMX‐based PBX was isotropic. The extent of strain in PBX was correlated with the thermal expansion coefficient of the crystal, although the final degree of expansion was not dependent on the initial range of strain. The ratchet growth of TATB‐based PBX was approximately 31 με greater than that of HMX‐based PBX.

Dynamic Compressive Properties of a PBX Analog as a Function of Temperature and Strain Rate

Experimental Technique for Ice under Dynamic Compressive Loading

Experimental Study on Dynamic Mechanical Properties of a Mock PBX

Technique for Combined Dynamic Compression–Shear Testing of PBXs

Strain Measurement on a PBX during Temperature Cycling Using Fibre Bragg Gauges

Study on Compression–expansion Behaviour of PBXs Substitutive Materials

Mechanical Behavior of a PBX Substitute Material under Static and Dynamic Loading

Compressive Behavior of Engineered Cementitious Composites under High Strain-Rate Loading

Strength of Concrete Filled Steel Tubes under High-Strain Rate Loading

Study on the Relation Between Microstructural Change and Compressive Creep Stress of a PBX Substitute Material

Deformation and Failure of Polymer Bonded Explosives under Diametric Compression Test

Effects of Concentration and Temperature on Mechanical Properties of Tatb/Pctfe Pbx by Molecular Dynamics Simulation

Dynamic shear response of a polymer bonded explosive using a modified Hopkinson bar apparatus

Compressive Behavior and Damage Evaluation of a PBX Substitute Material

Visco-hyperelastic constitutive modeling of the dynamic mechanical behavior of HTPB casting explosive and its polymer binder

Effect of Strain Rate on the Compressive Behavior of Polyurethane Bonding

Experimental and Numerical Investigation of Dynamic Damage and Load Transfer of PBX Substitute Material under Low Velocity Impact

Attenuation Characteristics of Stress Amplitude in PBXs Substitute Materials under Air Gun Loading

The Dynamic Mechanical Behaviour and the Statistical Crack Mechanics Model for a Polymer-bonded Explosive

Experimental Study on the Microstructures and Dynamic Behavior of a PBX Substitute Material

A Study of Creep Properties of Polymer Bonded Explosives