Abstract:The green wave coordinated control model has evolved from the basic bandwidth maximization model to the multiweight approach to an asymmetrical multiband model and a general signal progression model with phase optimization to improve the operational efficiency of urban arterial roads and reduce driving delays and the amount of exhaust gas generated by vehicles queuing at intersections. However, most of the existing green wave models of arterial roads are based on a single phase pattern and little consider the optimization of the combination of multiple phase patterns. Initial queue clearing time is also considered at the green wave progression line in the time–space diagram, which leads to a waste of green light time. This study proposes a coordination control optimization method based on an asymmetrical multiband model with phase optimization to address the abovementioned problem. This model optimizes four aspects in the time–distance diagram: phase pattern selection, phase sequence, offset, and queue clearing time. Numerical experiments were conducted using the VISSIM micro traffic simulation tool for intersections along Kunlunshan South Road in Qingdao, and the effect of green wave coordination was evaluated using hierarchical analysis and compared with the signal-timing schemes generated by the four models: the multiweight approach, the improved multiweight approach, an asymmetrical multiband model, and a general signal progression model with phase optimization. The results show that an asymmetrical multiband model with phase optimization obtains a total bandwidth of 314 s in both directions. In the outbound direction, average number of stops, average travel speed, average travel time, and average delay time improve by 16%, 7.9%, 17.9%, and 15.6%, respectively. In the inbound direction, they improve by 43.7%, 16.1%, 40.7%, and 36%, respectively. Polluting gas emissions and fuel consumption improve by 17.9%. The applicability of the optimization method under different traffic flow conditions is analyzed, and results indicate a clear control effect when the traffic volume is moderate and the turning vehicles on the feeder roads are few. This work can provide a reference for the optimization of subsequent arterial signal coordination and also has indirect significance for environmental protection to a certain extent.

Coordinated Control Strategies of Beijing Ring Freeway Based on Improved AMOC

Based on Simulation Method for Solving Traffic Jam Problems.

Coordination Control Strategy of Urban Expressway On-ramp and Off-ramp

On-ramp metering control strategy of urban expressway

Coordinated Control of Urban Expressway Networks Via MPC

Ideas and Methods for Mixed Urban Traffic Control

Simulation of the Frontage Road Control Near the Expressway Exit Ramp

On-ramp Metering on Beijing Urban Expressway

Coordinated Control Strategy of On-Ramp and Adjacent Intersection

A Decentralized Model Predictive Traffic Signal Control Method with Fixed Phase Sequence for Urban Networks.

Congestion dissipation strategy of urban expressway

Traffic Control Strategy for a Surface Street on an Expressway-Arterial Corridor

Signal coordination control for traffic bottleneck using OD data

Arterial Coordination Control Optimization Based on AM–BAND–PBAND Model

A Traffic Flow Model and Intelligent Control Technique for Urban Trunk Road

A model predictive control strategy for the auxiliary road adjacent to the freeway off-ramp

A Coordinated Optimization Strategy of Variable Speed Limit and Ramp Metering for Expressway

Traffic Scheduling and Control in Fully Connected and Automated Networks

Cooperative Route Guidance and Flow Control for Mixed Road Networks Comprising Expressway and Arterial Network

Distributed coordinated control of mixed expressway and urban roads: a sensitivity-based approach

A simulation study on on-ramp control for expressways in Beijing