Abstract:Currently, we have limited knowledge of the physical and chemical properties of emitted primary combustion aerosols and the changes in those properties caused by nucleation, condensation growth of volatile species, and particle coagulations under dilution and cooling in the ambient air. A dilution chamber was deployed to sample exhaust from a pilot-scale furnace burning various fuels at a nominal heat input rate of 160 kW/h(-1) and 3% excess oxygen. The formation mechanisms of particles smaller than 420 nm in electrical mobility diameter were experimentally investigated by measurement with a Scanning Mobility Particle Sizer (SMPS) as a function of aging times, dilution air ratios, combustion exhaust temperatures, and fuel types. Particle formation in the dilution process is a complex mixture of nucleation, coagulation, and condensational growth, depending on the concentrations of available condensable species and solid or liquid particles (such as soot, ash) in combustion exhausts. The measured particle size distributions in number concentrations measured show peaks of particle number concentrations for medium sulfur bituminous coal, No. 6 fuel oil, and natural gas at 40-50 nm, 70-100 nm, and 15-25 nm, respectively. For No. 6 fuel oil and coal, the particle number concentration is constant in the range of a dilution air ratio of 50, but the number decreases as the dilution air ratio decreases to 10. However, for natural gas, the particle number concentration is higher at a dilution air ratio of 10 and decreases at dilution air ratios of 20-50. At a dilution air ratio of 10, severe particle coagulation occurs in a relatively short time. Samples taken at different combustion exhaust temperatures for these fuel types show higher particle number concentrations at 645 K than at 450 K. As the aging time of particles increases, the particles increase in size and the number concentrations decrease. The largest gradient of particle number distribution occurs within the first 10 sec after dilution but shows only minor differences between 10 and 80 sec. The lifetimes of the ultrafine particles are relatively short, with a scale on the order of a few seconds. Results from this study suggest that an aging time of 10 sec and a dilution air ratio of 20 are sufficient to obtain representative primary particle emission samples from stationary combustion sources.

Real-Time Characterization of the Composition of Individual Particles Emitted from Ultrafine Particle Concentrators

Characterizing the Chemical Profile of Incidental Ultrafine Particles for Toxicity Assessment Using an Aerosol Concentrator

Review of Online Measurement Techniques for Chemical Composition of Atmospheric Clusters and Sub-20 Nm Particles

Chemical composition of different size ultrafine particulate matter measured by nanoparticle chemical ionization mass spectrometer

Mixing State of Atmospheric Particles over the North China Plain

Chemically Resolved Respiratory Deposition of Ultrafine Particles Characterized by Number Concentration in the Urban Atmosphere

Review of Measurement Methods and Compositions for Ultrafine Particles

Measurement of ultrafine particle size distributions from coal-, oil-, and gas-fired stationary combustion sources.

Secondary Formation of Submicron and Supermicron Organic and Inorganic Aerosols in a Highly Polluted Urban Area

Characterization of indoor particle sources using continuous mass and size monitors

Field Characterization of the PM 2.5 Aerosol Chemical Speciation Monitor: Insights into the Composition, Sources, and Processes of Fine Particles in Eastern China

Aerosol monitoring during carbon nanofiber production: mobile direct-reading sampling

Composition of Ultrafine Particles in Urban Beijing: Measurement Using a Thermal Desorption Chemical Ionization Mass Spectrometer.

Molecular Characterization of Ultrafine Particles Using Extractive Electrospray Time-of-flight Mass Spectrometry

Design and Characterization of Human Exposure to Generated Sulfate and Soot Particles in a Pilot Chamber Study.

Complex Aerosol Characterization by Scanning Electron Microscopy Coupled with Energy Dispersive X-ray Spectroscopy

Modeled Deposition of Fine Particles in Human Airway in Beijing, China

Insights into the compositional differences of PM1 and PM2.5 from aerosol mass spectrometer measurements in Beijing, China

Real-time, single-particle measurements of ambient aerosols in Shanghai

Real-time, single-particle chemical composition, volatility and mixing state measurements of urban aerosol particles in southwest China

Formation and Growth of Ultrafine Particles from Secondary Sources in Bakersfield, California