Abstract:In the traditional load model, motor and static loads are used to represent electrical equipment. However, since the electrical equipment using power electronic interface has accounted for a large proportion at present, the load components should be divided into motor, static load and power-electronic-interfaced load. The composition of the electric load is time-varying, and mastering the proportion of different load components is the key to establish an accurate load model. The existing load component proportion identification method identifies the key parameters of the load model and motor proportion parameters under large disturbances. However, the accuracy of this method is affected by the accuracy of load model parameters; moreover, it cannot identify the proportion of three types of load components. To this end, based on the analysis of different response characteristics of motor, static load and power-electronic-interfaced load under large disturbance, this paper proposes a load component proportion identification method based on dynamic response under large disturbance. This method first determines the proportion of static load according to the drop value of active power of load during the duration of large disturbance; then, the proportion of power-electronic-interfaced load is determined according to the separation results of motor response and the highest fitting accuracy; finally, the proportion of motor load can be calculated. The case study shows that the method does not depend on other parameters in the load model and has high identification accuracy.

Online Identification of Percentage of Dynamic Component in Composite Load Model

Identification of a composite load model with applications

Composite Load Models Based on Field Measurements and Their Applications in Dynamic Analysis

Identification Method of the Load Component Proportion Based on the Dynamic Response under Large Disturbance

Comparison of three composite induction motor load models

A Composite Induction Motor Load Model for Conversion Between Different Voltage Sides Through the Transmission Element

Component Based On-line Modeling for Electric Loads

Sequential Parameter Estimation of a Simplified Induction Motor Load Model

STUDIES ON CLASSIFICATION AND SYNTHESIS OF COMPOSITE DYNAMIC LOADS

A Dynamic Equivalent Method for Induction Motors Based on Dynamic Similarity and Buffer Zone

Modeling and Simulation of Non-Linear Dynamic Process of the Induction Motor System with Fluctuating Potential Loads

ON-LINE IDENTIFICATING OF THE PROPORTION OF DYNAMIC COMPONENT IN COMPOSITE LOAD MODEL

Fast Online Identification of the Dominant Parameters of Composite Load Model Using Volterra Model and Pattern Classification

Modeling of Common-Mode Impedance of an Inverter-Fed Induction Motor from Online Measurement

A Two-Step Method for Online Parameter Identification of a Simplified Composite Load Model

Parameter Identification Of Inverter-Fed Induction Motors: A Review

Key Techniques for Composite Load Area Integral Equivalence and Online Parameter Identification

Fast Parameter Identification and Modeling of Electric Load Based on Simplified Composite Load Model

Comparative Study of Transfer Function Based Load Model and Composite Load Model

Online Multi-Parameter Identification of PMSM Based on High Frequency Equivalent Impedance Model

Decoupled Offline Parameter Identification of Induction Motors