Abstract:During five-axis cutting, the unreasonable selection of the tool’s diameter and processing width will greatly affect processing efficiency. However, the existing tool’s diameter and processing width values avoid local over-cutting, which is conservative. Therefore, a calculation method of optimal cutting diameter and processing width based on machining interference surface with flat-end cutter as the research object is proposed in this paper. First, the offset surface of discrete points is constructed as the machining interference surface based on the implicit surface theory. The surface offset is the maximum allowable machining error. Then, according to the Dupin indicatrix line between the tool and the machining surface, sufficient and necessary conditions for the local malleability of the flat-end cutter are obtained. Based on the constructed machining interference surface, the optimal diameter of the tool is calculated via the effective cutting profile curve of the tool at the interference surface. Next, the next cutter contact point is obtained by intersecting the tangent line between the cutter contact point and the upper or lower limit surface of the machining interference surface and the cutting path curve. The processing width is calculated according to the distance between the two adjacent cutter contact points. Finally, the proposed algorithm is verified by CAM software simulation and experiments by taking a complex surface as an example. The experimental results show that the optimization algorithm of the tool’s diameter and bandwidth under the constraint of machining interference surface can shorten the machining time and obtain higher machining efficiency in the NC machining of complex surfaces.

Optimal tools selecting and tool-path planning based on MAT

Optimization Empty Run for CNC Multi-contour Processing

Approach optimizing tool paths arrangement based on genetic algorithm

NC process information mining based optimization method of roughing tool sequence selection for pocket features

A Computer Aided Tool Selection System For 3d Die/Mould-Cavity Nc Machining Using Both A Heuristic And Analytical Approach

An Effective Numerical Control Machining Process Optimization Approach of Part with Complex Pockets for Numerical Control Process Reuse.

Machining Speed Enhancement for Free-form Surface of Cross-sectional Design Based on Step Length Optimization

An Effective Adaptive Dynamic Evolution Computing Approach of Roughing Process for Part with Complex Pockets

Isoscallop of Self-Adaptive Tool Orientation with Toroidal Cutter under Optimum Orientation of MCPs

Research on tool diameter and processing width optimization for highly efficient machining of complex surfaces constrained by machining interference surface

Optimization of Cutter Orientation for Multi-Axis NC Machining Based on Minimum Energy Consumption of Motion Axes

Optimization of the Cutter Size and Tool Orientation for Reaching the Critical State with Multi-Constraints in Deep and Narrow Channel Parts Machining

Optimal Cutting Directions by Considering the Dynamic Mismatch Between Feed Axes of Machine Tools

Generating Collision-Free Tool Orientations For 5-Axis Nc Machining With A Short Ball-End Cutter

New Approach To Selecting Multiple Tools For Milling 2.5-D Pockets

Tool Selection of Multi-axis Machining for Channel Parts with Sculptured Surface

Efficient Algorithm for Finishing NC Tool Path Generation Based on Triangular Bézier Surface

Tool Orientation Planning in Milling with Process Dynamic Constraints: A Minimax Optimization Approach

Enveloping theory based method for the determination of path interval and tool path optimization for surface machining

Toolpath Optimization for C2 Continuous Machining

Research on Multi-axis Machining Tool Path Generation Algorithm