Abstract:It is essential to bias a thin-film lithium-niobate Mach-Zehnder electro-optic (EO) modulator at the desired operation condition to ensure optimal performance of the modulator. While thermo-optic (TO) control can solve the problem of bias drift, it consumes significant electric power. In this paper, we propose a technique to largely reduce bias power consumption by combining passive bias and TO bias. In our design, waveguide sections with different widths are introduced in the two arms of the MZ modulator to produce a desired phase difference of π/2 rad (the desired operation condition), and local heating with electrode heaters placed on the waveguides is employed to provide compensation for any phase drift caused by fabrication errors and other effects. As the TO control only serves to compensate for small errors, the electric power required is low and the response is fast. To demonstrate our technique experimentally, we fabricate several modulators of the same design on the same chip. Our experimental modulators can operate up to ∼40 GHz with a half-wave voltage of ∼2.0 V over a wide optical bandwidth, and the performances are insensitive to ambient temperature variations. The TO bias powers required range from 1 mW to 15 mW, and the thermal rise and fall times are 47 µs and 14 µs, respectively. Our technique can facilitate the development of practical high-speed EO modulators on the lithium-niobate-on-insulator platform.

Effect of dither tone-based electro-optic modulator bias control on radio-frequency signal

Any bias point control of mach-zehnder electrooptic modulator and its applications in optimization of radio-over-fiber links

Bias Control Approach Based on VMD and LIA Demodulation of a Lithium Niobate Polarization Controller.

Bias Controller of Mach-Zehnder Modulator for Electro-Optic Analog-to-Digital Converter

Modulator Bias Control Based on Bi-PID Algorithm for Optical Time and Frequency Transmission

Modulator Bias Control Based on Dither Signal in 40gb/s RZ Optical Transmission System

Coherent Detection-Based Automatic Bias Control of Mach–Zehnder Modulators for Various Modulation Formats

High Accuracy Microwave Frequency Measurement Based on Single-Drive Dual-Parallel Mach-Zehnder Modulator

Different Effects on Bandwidth for Traveling-Wave Quantum Well Electro-Absorption Modulator and Bulk Mach-Zehnder Electric-Opto Modulator

Performance Analysis of Automatic Feedback Control for Multiple Bias Voltages in Optical Quadrature Phase-Shift Keying Modulator

Electro-optic Modulator Feedback Control in Phase-Sensitive Optical Time-Domain Reflectometer Distributed Sensor.

Performance Improvement of Phase Modulation with Interferometric Detection Through Low-Biasing

Breaking the Baud Rate Ceiling of Electro-Optic Modulators Using Optical Equalization Technique

A General Analytical Method for Suppressing the Third-Order Intermodulation in Microwave Photonic Link Based on Dual-Parallel Mach–Zehnder Modulator

Thin-film Lithium-Niobate Modulator with a Combined Passive Bias and Thermo-Optic Bias

Investigation of a Type of Mach–Zehnder Modulator Based on Optical Bias

Influence of Doping Position on the Extinction Ratio of Mach-Zehnder-Interference Based Silicon Optical Modulators

Influence Of Loss On Linearity Of Microring-Assisted Mach-Zehnder Modulator

A Silicon Optical Single Sideband Modulator with Ultra-High Sideband Suppression Ratio

Test and Analysis of the Optical Kerr-Effect in Resonant Micro-Optic Gyros

Forward bias operation of silicon photonic Mach Zehnder modulators for RF applications