Abstract:With the rapid development of high-speed railway (HSR) in China, the problem of environmental vibration induced by HSR train has attracted critical concern. In this paper, a combination vibration reduction (CVR) strategy of hollow-closed-wall in-filled trench (HIT) and elastic bearing (EB) is proposed to decrease environmental vibration induced by HSR train, in which the depth of HIT could be well controlled to benefit the practical construction and economic cost. Based on the multi-body dynamics and finite element theory, HSR environmental vibration system is established and then divided into two sub-models including the 'train-track-bridge' vibration source sub-model and the 'pile-soil' vibration propagation sub-model. The two sub-models are connected via the force balance condition of the pier bottom. The verification of numerical models is conducted by comparing with the empirical formula and the ground data in the references. Then the attenuation law of environmental vibration is analyzed, and the vertical component is shown to be dominant in the HSR environmental vibration. On this basis, numerical simulations are performed to analyze the environmental vibration reduction under three strategies, namely the HIT, EB, and CVR. The results show that the HIT presents a distinct vibration reduction effect in the frequency range above 4 Hz and the vibration reduction becomes more obvious as the HIT's depth increases. However, the depth should be larger than 8 m to satisfy the code requirement; the EB presents an obvious reduction in the frequency range above 8 Hz; the CVR strategy not only further decrease the environmental vibration, but also effectively reduce the HIT's depth. By numerical analysis, the combination strategy of 6 m deep HIT and 2200 kN/mm vertical stiffness EB is recommended in the HSR environmental vibration reduction, which could also satisfy the limit of Chinese railway code.

On Effectiveness of Vibration Isolation Using Super-Elastic Rail Support Combined with Booted Sleeper or Floating Slab

An Acoustic Black Hole Absorber for Rail Vibration Suppression: Simulation and Full-Scale Experiment

Effects of Steel Spring Floating Slab on Vibration and Noise of a Rail Transit Box-Girder

A Theoretical Investigation on Influences of Slab Tracks on Vertical Dynamic Responses of Railway Viaducts

A Combination Strategy of Hollow-Closed-wall In-Filled Trench and Elastic Bearing for Reducing Environmental Vibration Induced by High-Speed Train

Vibration Reduction Performance of a Periodic Layered Slab Track

Vibration Characteristics of Damping Pad Floating Slab on the Long-Span Steel Truss Cable-Stayed Bridge in Urban Rail Transit

Study on stiffness matching strategy of longitudinal sleeper and fastener to reduce tunnel wall vibration

Influence of Vibration Isolator Failure on Vehicle Operation Performance and Floating Slab Track Structure Vibration Reduction Effectiveness

Mitigation of Ground Vibration Generated by High-Speed Trains on Saturated Poroelastic Ground with Under-Sleeper Pads

Vibration-reduction optimization of the point-supporting floating-slab track based on local resonance mechanism

Study of Ground Vibration from Trains Caused by Track Irregularities

Environmental noise and vibration characteristics of rubber-spring floating slab track

Effect of Rail Rigidity on Track-Ground Vibration Due to a High-Speed Train

Reduction of ground-borne vibrations from rail lines on viaducts by means of elastic anti-vibration mats

Effects of the Dynamic Wheel–rail Interaction on the Ground Vibration Generated by a Moving Train

Optimum Analysis of Vibration Reduction Performance for Floating Slab Track Based on Shear Hinge

Application and long-term effects of vibration reduction in CRTSIII slab track: Insights from field measurements

A substructure approach for analyzing pile foundation and soil vibrations due to train running over viaduct and its validation

Experimental Study on Vibration Characteristics of Unit-Plate Ballastless Track Systems Laid on Long-Span Bridges Using Full-Scale Test Rigs

Comparative experimental investigation of the vibration mitigation characteristics of ballasted track using the rubber composite sleeper and concrete sleeper under various interaction forces