Abstract:Fission processes of the excited compound nuclei Tl197, Fr217, Th224 , and Fm254 in a wide range of mass numbers produced in fusion reactions have been simulated in the framework of the modified statistical model and different observables were reproduced for these nuclei. In the statistical calculations have been considered the effects of the projection of the total spin of the compound nucleus onto the symmetry axis K , the temperature dependence of the location and height of fission transition points, and the classical collective motion of the excited compound nuclei about the ground state. Furthermore, in the present research, particle binding energies as a function of deformation of nuclei and subbarrier fission have been considered for more accurate reproduction of the experimental data. The fission cross section, the evaporation residue cross section, the fission probability, the average prescission neutron multiplicity, and the anisotropy of fission fragments' angular distribution have been calculated for the excited compound nuclei Tl197, Fr217, Th224 , and Fm254 . In the statistical simulations, the scaling factor of the fission barrier height, rs , and the temperature coefficient of the effective potential, k , were considered as a free parameter. For each reaction the parameters rs and k were adjusted to reproduce a single fission cross section and a single evaporation residue cross section. It was shown that the results of calculations are in good agreement with the experimental data by using appropriate values for these parameters equal to k=0.0182±0.0050MeV−2 and rs=1.0005±0.0020 for Tl197 ; k=0.0063±0.0040MeV−2 and rs=1.0042±0.0015 for Fr217 ; k=0.0060±0.0040MeV−2 and rs=1.0050±0.0020 for Th224 ; k=0.0025±0.0015MeV−2 and rs=1.0100±0.0014 for Fm254 . Furthermore, by using appropriate values of parameters k and rs I have calculated the average prescission neutron multiplicity, the fission probability, and the anisotropy of fission fragments' angular distribution for the compound nuclei Tl197, Fr217, Th224 , and Fm254 . It was shown that the modified statistical model is well able to reproduce different experimental data, although at high excitation energies the results of calculations for the neutron multiplicity and the anisotropy of fission fragments' angular distribution are slightly lower than the experimental data. It was also shown that, at high excitation energy, for reproducing the neutron multiplicity one needs to increase the nuclear dissipation. Finally, from the comparison of the extracted results of parameters k and rs for the compound nuclei Tl197, Fr217, Th224 , and Fm254 , it was shown that the parameter k decreases and the parameter rs increases with increasing mass number of the compound nucleus. https://doi.org/10.1103/PhysRevC.109.064624 ©2024 American Physical Society

Calculations of the Anisotropy of the Fission Fragment Angular Distribution and Neutron Emission Multiplicities Prescission from Langevin Dynamics

Analysis of nuclear fission properties with the Langevin approach in Fourier shape parametrization

The influence of the boundary conditions on characteristics of nuclear fission

Impact of nuclear dissipation on the fission dynamics within the Langevin approach

Towards a unified description of isotopic fragment properties in spontaneous and fusion-induced fission within a 4D dynamical Langevin model

Five-dimensional Langevin approach to fission of atomic nuclei

The 5-dimensional Langevin approach to fission of atomic nuclei

Temperature Dependent Fission Fragment Distribution in the Langevin Equation

Angular Momentum of Fission Fragments from Microscopic Theory

Multi-parameter Global Calculations of Fission Fragments Using a Simplified Two-Dimensional Scission-Point Model

Effects of viscosity and scission configuration on the fission dynamics of the excited compound nucleus produced in neutron-induced reactions

Isoscaling of the Fission Fragments with Langevin Equation

Fission Fragment Mass and Kinetic Energy Yields of Fermium Isotopes

Fission fragment charge and mass distributions in 239Pu(n,f) in the adiabatic nuclear energy density functional theory

Fission dynamics, dissipation and clustering at finite temperature

Isoscaling Behavior in Fission Dynamics

Statistical modeling of the fission process of , and nuclei produced in heavy ion reactions within the modified statistical model

Quantification of spin alignment in fission by simultaneous treatment of and conversion electron angular distributions

Multimodality of fission studied by the Langevin approach

Study of Neutron Induced Fission of Actinides in a Macroscopic-Microscopic Model

Quantification of spin alignment in fission by simultaneous treatment of gamma and conversion electron angular distributions