Abstract:Utilizing crystalline-amorphous block copolymers, such as in the case of polystyrene-block-poly(ethylene oxide) (PS-b-PEO), under a large amplitude shear process provides an opportunity for investigating crystal growth and orientation within nanoconfinements at different supercoolings. However, the internal stress generated during the shearing process and the structural defects embedded in the phase-separated morphology inevitably play roles in affecting the confinement effect on the crystallization of the crystalline blocks. In this study, we designed a one-dimensional (1D), defect-free confinement constructed by PS-b-PEO single crystal mats collected in dilute solution. Each single crystal possessed a square-shaped, "sandwiched" lamellar structure, and it consisted of a PEO single crystal layer between two PS nanolayers formed by the tethered PS blocks on the PEO single crystal top and bottom fold surfaces. Furthermore, in these single crystal mats the glass transition temperature of the PS blocks is higher than the melting temperature of the PED single crystals. We melted the PEO crystals between the two vitrified PS nanolayers, and the PEO blocks were recrystallized isothermally by quenching the mats to preset recrystallization temperatures (T-rx). The orientation change of the PEO crystals with respect to the "sandwiched" lamellar normal at different T-rx values was investigated via 2D small-angle and wide-angle X-ray scattering experiments. It was observed that the PEO c-axis orientation under-went a sharp change from homogeneous (perpendicular to the lamellar normal) in the low T-rx region to approximately homeotropic (parallel to the lamellar normal) in the high T-rx region. The results showed that this change of the PEO crystal orientation takes place within a few degrees Celsius. Microscopically, the crystal orientation might be determined from the status of critical nuclei formation due to the size and shape of this ID confinement. This likely included a competition between the high tethering density (the junctions) of the PEO blocks at the PS interfaces leading to the homeotropic orientation with an anisotropic conformational orientation of the PED blocks in the melt and the anisotropic density fluctuations within the ID confined layer which could lead to an anisotropic ability for the PEO blocks to overcome the nucleation barrier to form the homogeneous orientation. The resolution of these two factors might explain the origin of the crystal orientation change in ID confined crystallization. Analysis of the apparent crystallite size in these mats along both the orthogonally oriented [120] directions of the PEO crystals after recrystallization indicated that a change in the PEO crystal growth dimension from 1D to 2D occurs within this narrow T-rx region corresponding to the location of the crystal orientation change.

Understanding crystal orientation in quasi-one-dimensional polymer systems

Orientation Transition of Nanorods Induced by Polymer Brushes

Competition of crystal nucleation to fabricate the oriented semi-crystalline polymers

Molecular simulation of crystallization of polymers confined in cylindrical nanodomain

Controllability of Polymer Crystal Orientation Using Heterogeneous Nucleation of Deformed Polymer Loops Grafted on Two-Dimensional Nanofiller

Coherent crystal branches: the impact of tetragonal symmetry on the 2D confined polymer nanostructure

Polymer Crystallization under Nano-Confinement of Droplets Studied by Molecular Simulations.

Crystal Orientation Change and Its Origin in One-Dimensional Nanoconfinement Constructed by Polystyrene-Block-Poly(Ethylene Oxide) Single Crystal Mats

Biaxial Stretch-Induced Crystallization of Polymers: A Molecular Dynamics Simulation Study

Observing polymerization in 2D dynamic covalent polymers

Molecular Simulation of Crystal Nucleation and Growth of Structurally Restricted Polymer Nanocomposites

Alignment controlled growth of single-walled carbon nanotubes on quartz substrates.

Confined Crystallization of Cylindrical Diblock Copolymers Studied by Dynamic Monte Carlo Simulations

A nucleation mechanism leading to stacking of lamellar crystals in polymer thin films

Oriented Primary Crystal Nucleation in Lamellar Diblock Copolymer Systems.

Regime Transitions of Polymer Crystal Growth Rates: Molecular Simulations and Interpretation Beyond Lauritzen-Hoffman Model

Relaxation and Crystallization of Oriented Polymer Melts with Anisotropic Filler Networks

Insights from Polymer Crystallization: Chirality, Recognition and Competition

Formation Mechanism of Reverse Kebab Structure Inside Hollow Nanotubes Studied by Molecular Simulations

The Tough Journey of Polymer Crystallization: Battling with Chain Flexibility and Connectivity

Precursor formation and crystal nucleation in stretched polyethylene/carbon nanotube nanocomposites