Abstract:Forty two major (Na, Mg, Ti and Mn) and trace elements covering the mass range from Li to U in three USGS basalt glass reference materials BCR-2G, BHVO-2G and BIR-1G were determined using laser ablation-inductively coupled plasma-mass spectrometry. Calibration was performed using NIST SRM 610 in conjunction with internal standardisation using Ca. Determinations were also made on NIST SRM 612 and 614 as well as NIST SRM 610 as unknown samples, and included forty five major (Al and Na) and trace elements. Relative standard deviation (RSD) of determinations was below 10% for most elements in all the glasses under investigation. Consistent exceptions were Sri and Sb in BCR-2G, BHVO-2G and BIR-1G. For BCR-2G, BHVO-2G and BIR-1G, clear negative correlations on a logarithmic scale exist between RSD and concentration for elements lower than 1500 mug g(-1) with logarithmic correlation coefficients between -0.75 and -0.86. There is also a clear trend of increasing RSD with decreasing concentration from NIST SRM 610 through SRM 612 to SRM 614. These suggest that the difference in the scatter of apparent element concentrations is not due to chemical heterogeneity but reflects analytical uncertainty. It is concluded that all, these glasses are, overall, homogeneous on a scale of 60 mum.Our first results on BHVO-2G and BIR-1G showed that they generally agreed with BHVO-2/BHVO-1 and BIR-1 within 10% relative. Exceptions were Nb, To and Pb in BHVO-2G, which were 14-45% lower than reference values for BHVO-2 and BHVO-1. Be, Ni, Zn, Y, Zr, Nb, Sri, Sb, Gd, Tb, Er, Pb and U in BIR-1G were also exceptions. However, of these elements, Be, Nb, Sn, Sb, Gd, Tb, Pb and U gave results that were consistent within an uncertainty of 2s between our data and BIR-1 reference values. Results on NIST SRM 612 agreed well with published data, except for Mg and Sn. This was also true for elements with m/z greater than or equal to 85 (Rb) in the case of NIST SRM 614.The good agreement between measured and reference values for No and Mg in BCR-2G, BHVO-2G and BIR-1 G, and for A and Na in NIST SRM 610, 612 and 614 up to concentrations of at least several weight percent (which were possible to analyse due to the dynamic range of 108) indicates the suitability of this technique for major, minor and trace element determinations.

The primary development of glass rock standard by high temperature fusion: Basalt as an example

Primary Research on A Synthetic Experimental Method of Andesite Standard Glass References by Using High-Temperature Fusion

Quick and accurate LA-ICP-MS analyses of major and trace elements in basalt,coupled with glass fusion method by double iridium strip heater

Analysis of major and trace elements in basaltic achondrite based on laser fusion

Simultaneous Determination of Major and Trace Elements in Fused Volcanic Rock Powders Using A Hermetic Vessel Heater and La-Icp-Ms

Simultaneous Determination of Trace Elements and Lead Isotopes in Fused Silicate Rock Powders Using a Boron Nitride Vessel and fsLA-(MC)-ICP-MS

A Flux‐Free Fusion Technique for Rapid Determination of Major and Trace Elements in Silicate Rocks by LA‐ICP‐MS

Three Natural Andesitic to Rhyolitic Glasses ( OJY-1, OH-1, OA-1) As Reference Materials for in Situ Microanalysis

Flux-free fusion technique using a boron nitride vessel and rapid acid digestion for determination of trace elements by ICP-MS

Analysis of 42 Major and Trace Elements in Glass Standard Reference Materials by 193nm LA-ICPMS.

In Situ Analysis of Mg Isotopic Compositions of Basalt Glasses by Femtosecond Laser Ablation Multi-Collector Inductively Coupled Plasma Mass Spectrometry

A Preliminary Study of the Method for Synthetic Zircon Lu-Hf Isotopic Standard

Determination Of Forty Two Major And Trace Elements In Usgs And Nist Srm Glasses By Laser Ablation-Inductively Coupled Plasma-Mass Spectrometry

Quantitative analysis of trace element abundances in glasses and minerals: a comparison of laser ablation inductively coupled plasma mass spectrometry, solution inductively coupled plasma mass spectrometry, proton microprobe and electron microprobe data

Contrasting Matrix Induced Elemental Fractionation in NIST SRM and Rock Glasses During Laser Ablation ICP-MS Analysis at High Spatial Resolution

In situ determination of trace elements in melt inclusions using laser ablation-inductively coupled plasma-sector field-mass spectrometry.

Combined use of multiple external and internal standards in LA-ICP-MS analysis of bulk geological samples using lithium borate fused glass

Simultaneous measurement of major, trace elements and Pb isotopes in silicate glasses by laser ablation quadrupole and multi-collector inductively coupled plasma mass spectrometry

Strontium isotope measurement of basaltic glasses by laser ablation multiple collector inductively coupled plasma mass spectrometry based on a linear relationship between analytical bias and Rb/Sr ratios.

High spatial resolution trace element determination of geological samples by laser ablation quadrupole plasma mass spectrometry: implications for glass analysis in volcanic products

Trace elements determination by femtosecond LA-ICP-MS of 10 mg extraterrestrial geological samples prepared as lithium borate glasses