Laser Emission With Hybrid Resonant Mode From An Active Peanut-Shaped Microcavity
Liying Liu,Lei Shang,Lei Xu
DOI: https://doi.org/10.1109/ICTON.2008.4598772
2008-01-01
Abstract:Two basic types of resonances exist in microcavities. One is whispering gallery mode (WGM) resonance which Occurs particularly in circular and elliptical-shaped micro-disks. The other type of resonance is mutiple-bouncing periodic orbit. Bow-tie bouncing modes found in a quadruple-shaped cavity and some types of scar modes in chaotic systems are typical examples. Emission directionality from a microcavity is an important property because achieving highly collimated emission (comparable to that of,I bulk laser system) from microcavity lasers is essential to obtain high brightness micro-light Sources for coupling with other optical systems. Asymmetric resonant cavities (ARCS) have been designed and fabricated to achieve laser emissions with directionality, however, the beam divergences of all those reported ARCS were found to be of ten degrees at least.In this work, we report an observation of directional laser emission with extremely narrow divergence (about 2 degrees) from a peanut-shaped microcavity. This narrow divergence is very promising for the microcavity to be used as micro-lasers with high brightness. We also demonstrated that the real resonance in a peanut-shaped microcavity is a very special hybrid resonance which combines a whispering gallery orbit and a two-bouncing orbit.The peanut-shaped microcavity was fabricated by coating dye doped organic/inorganic hybrid glass materials on a pair of fibers. A gain layer with 1.12 wt% laser dye (Rhodamine B, RhB) in the organic/inorganic hybrid matrix material (n = 1.52) was dip-coated on the stacked fiber to form a peanut-shaped boundary. The inset in Fig. 1 shows schematically a peanut-shaped microcavity. It is obvious that a peanut-shaped microcavity is a largely deformed cavity comparing with those in references, especially it has a concave Curvature, which is avoided in conventional microcavity design for resonances on WGMs. Fig. I plotted the integrated far-field laser emission intensity versus emission angle. Lasing from the cavity has four major strong emission peaks. The divergence of these strong peaks is 2 degrees. The very narrow divergence is striking when compared with the typical divergence in the other microcavities of over 10 degrees. Combining information oil mode spacing, far-field emission pattern and the lasing threshold. the most possible resonant orbit was found to be ail asymmetric hybrid resonance which consists half whispering gallery orbit and half two-bouncing orbit, as illustrated in Fig. 2. The divergent beam leaving left part of cavity is collimated by the curvature of the right cavity boundary that works like a ball lens. Therefore, an extreme narrow emission divergence is achieved. Comparing with other orbits Such as diamond-like orbits, the hybrid mode may not have the largest Q when a passive cavity is considered. as long as the two bouncing points are highly lossy. However, since a peanut-shaped cavity only has a very thin gain layer, for the hybrid mode, comparing to multiple-bouncing periodic loops. total gain is much larger because the WGM path overlaps with the gain area, therefore the hybrid mode becomes the most possible lasing mode.