Abstract:Mass flow rate measurement is very important in the majority of industry processes because the mass of fluid is not affected by ambient temperature and pressure as the volume will be. Conventional mass flow rate is normally derived from the volumetric flow rate multiplied by fluid density. The density can be obtained by a densitometer or calculated according to the temperature and pressure measured by a thermometer and pressure gauge respectively. However the measurement accuracy is not always satisfactory. Flowmeters directly measuring mass flow rate have been studied and developed recently, such as Coriolis and thermal flowmeters. Unfortunately they still have some limits in practical applications. A new method in which mass flow rate can be directly measured based on the vortex shedding principle is presented in this paper. As a vortex flowmeter, von Kàrmàn vortex shedding is generated by a bluff body (vortex shedder), leading to a pressure drop and pressure fluctuation. A single differential pressure sensor is employed to detect the pressure difference between upstream and downstream sides of the vortex shedder. Both vortex shedding frequency and pressure drop are contained from the output signal of the differential pressure sensor, so that the mass flow rate can be obtained from the pressure signal. Numerical simulation has been done to analyze the characteristics of the fluid field and design the measurement device. The Computational Fluid Dynamics (CFD) codes Fluent were used in the numerical simulation. Experiments were carried out with water and gas, and the results show that this method is feasible and effective to measure the mass flow rate. This method has also robustness to disturbances such as pipe vibration and fluid turbulence.

Measurement of Flow Fields in a Stirred Tank with a 3D Laser Doppler Velocimeter

Measuring Flow Velocity Distribution in Microchannels Using Molecular Tracers

MEASUREMENT AND NUMERICAL SIMULATION OF FLOW FIELD IN STIRRED TANK WITH MULTIPLE IMPELLERS

A Non-Contact Dynamic Attitude Measurement System Based on 3D Oblique Laser Doppler Vibrometers

Measurement of Two-Phase Velocities in Bubble Flows Using Laser Doppler Velocimetry

Progress of the Experimental Researches and Numerical Simulations of the Flow Fields in Stirred Tanks

A New Void Fraction Measurement Method for Gas-Liquid Two-Phase Flow in Small Channels.

Volumetric Three-Component Velocimetry: a New Tool for 3D Flow Measurement

Parameter Measurement System of Taylor Flow in Small Channels Based on Photodiode Array Sensors.

Online Parameters Measurement of Taylor Flow in Small Channels Using Optical Technique

Void Fraction Measurement Of Gas-Liquid Two-Phase Flow Based On (Cd)-D-4 Technique

Experimental Study of Influence of the Impeller Spacing on Flow Behaviour of Double‐Impeller Stirred Tank

NUMERICAL SIMULATION OF LAMINAR SOLID-LIQUID TWO-PHASE FLOW IN STIRRED TANKS

DPIV MEASUREMENT AND CFD SIMULATION OF VISCOUS FLUID FLOW IN STIRRED TANK AGITATED BY RUSHTON TURBINE

A study of mass flow rate measurement based on the vortex shedding principle

Study on the Measurement of Paste Flow Based on the Optical Fiber System

A New Method for Velocity Measurement of Gas-Liquid Two-Phase Flow Based on C~4D Technique

Experimental and Numerical Studies of the Flow Field in a Stirred Tank Equipped with Multiple Side‐Entering Agitators

Applications of Laser Doppler Velocimeter in Chemical Engineering

Free-Surface Velocity Measurement Using Direct Sensor Orientation-Based STIV

Investigation on swirling jet velocity using 3D-LDA technology