Abstract:Mass flow rate measurement is very important in the majority of industry processes because the mass of fluid is not affected by ambient temperature and pressure as the volume will be. Conventional mass flow rate is normally derived from the volumetric flow rate multiplied by fluid density. The density can be obtained by a densitometer or calculated according to the temperature and pressure measured by a thermometer and pressure gauge respectively. However the measurement accuracy is not always satisfactory. Flowmeters directly measuring mass flow rate have been studied and developed recently, such as Coriolis and thermal flowmeters. Unfortunately they still have some limits in practical applications. A new method in which mass flow rate can be directly measured based on the vortex shedding principle is presented in this paper. As a vortex flowmeter, von Kàrmàn vortex shedding is generated by a bluff body (vortex shedder), leading to a pressure drop and pressure fluctuation. A single differential pressure sensor is employed to detect the pressure difference between upstream and downstream sides of the vortex shedder. Both vortex shedding frequency and pressure drop are contained from the output signal of the differential pressure sensor, so that the mass flow rate can be obtained from the pressure signal. Numerical simulation has been done to analyze the characteristics of the fluid field and design the measurement device. The Computational Fluid Dynamics (CFD) codes Fluent were used in the numerical simulation. Experiments were carried out with water and gas, and the results show that this method is feasible and effective to measure the mass flow rate. This method has also robustness to disturbances such as pipe vibration and fluid turbulence.

Photoelectric velocity measuring system for slope flow based on virtual instrument technology

Virtual Design of Precision Irrigation Detection System

Voidage Measurement of Air-Water Two-phase Flow Based on ERT Sensor and Data Mining Technology

Flowrate measurement of air-water two-phase flow using an Electrical Resistance Tomography sensor and a Venturi meter

Implementation of Water Pipeline Leak Detecting and Location System Based on Virtual Instruments

Pipeline parameter identification of non-stationary flows based on LabVIEW

Parameter Measurement System of Taylor Flow in Small Channels Based on Photodiode Array Sensors.

Instrumentation of an Unsaturated Expansive Soil Slope

Measuring System for Furrow Opener Based on Virtual Instrument Technology

Study on intelligent measurement and analysis system of soil electric conductivity

Measurement of Surface Velocity Field in Mountainous River Channel Based on Image Processing

Air–water two-phase flow measurement using a Venturi meter and an electrical resistance tomography sensor

A study of mass flow rate measurement based on the vortex shedding principle

Research on Relationships Between Sediment Yield and Hydraulics Parameters on Slope

Research of Accuracy of Flow Measurement with Virtual Instrument

Flow measurements in sewers based on image analysis: automatic flow velocity algorithm

Study on the Measurement of Paste Flow Based on the Optical Fiber System

Study on crop irrigation system based on the virtual instrument technique

Virtual Instrument For Steam Two-Parameter Measurement Based On Orifice Plate Differential Pressure Noise

An In-Situ Method for Measuring Surface Topography and Velocity Field of Flood Flow Discharged from High-Dam Reservoir

Research and development of the measurement system for current field based on virtual instrumentation technology