Design of an ADC for subsampling video applications

Jian Li,Xiaoyang Zeng,Jianyun Zhang,Lei Xie,Huan Deng,Yawei Guo
DOI: https://doi.org/10.1007/s10470-006-9707-z
IF: 1.321
2006-01-01
Analog Integrated Circuits and Signal Processing
Abstract:This paper describes a 10 bit 30 Msample/s (MSPS) CMOS analog-to-digital converter (ADC) for high-speed signal processing, especially for subsampling applications, for example digital video broadcasting over cable (DVB-C), terrestrial (DVB-T) and handheld (DVB-H) systems. The proposed pipelined ADC shows a good figure-of-merit (FoM). It adopts a power efficient amplifier sharing technique, a symmetrical gate-bootstrapping technique with modified timing for the bottom-sampling switch of a wideband sample-and-hold (S/H) circuit, a proposed stable high-swing bias circuit for a wide-swing gain-boosting telescopic amplifier. The measured differential and integral nonlinearities of the prototype in a 0.25-μm CMOS technology show less than 0.4 least significant bit (LSB) and 0.85 LSB respectively at full sampling rate. The ADC exhibits higher than 9 effective number of bits (ENOB) for input frequencies up to about 60 MHz, which is the fourfold Nyquist rate (fs/2), at 30 MSPS. The ADC consumes 60 mW from a 3-V supply and occupies about 1.36 mm 2 .
What problem does this paper attempt to address?