Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Transition Condensation Heat Transfer Model with Liquid-Solid Surface Free Energy Difference Effect

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Lattice Boltzmann Modeling of Condensation Heat Transfer on Downward-Facing Surfaces with Different Wettabilities

Thin liquid film flow and heat transfer under spray impingement

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Investigation of filmwise condensation and flow characteristics on inner curved heat transfer surface

Coupling droplets/bubbles with a liquid film for enhancing phase-change heat transfer

Effects of Liquid Film Waviness, Suction, and Fog Formation on Condensation in the Presence of Noncondensable Gases

Determination of Mass Transfer Coefficient for Condensation Simulation

Advances in modeling investigations of multimode dropwise condensation heat transfer on smooth and textured surfaces – A review

Diffusion Layer Model for Condensation of Vapor with the Presence of Noncondensable Gas under Natural Convective Condensation

Numerical Investigation of Heat Transfer and Development in Spherical Condensation Droplets

The condensation characteristics of individual droplets during dropwise condensation

The enhancement effects of internal convection on the heat transport of condensing droplets out of pure steam and moist air

Theoretical Modeling of Vapor Condensation in the Presence of Noncondensable Gas on a Horizontal Tube

Interfacial cooling and heating, temperature discontinuity and inversion in evaporation and condensation

Numerical Simulation of Flow Patterns and the Effect on Heat Flux During R32 Condensation in Microtube

Numerical Study of the Forced Convective Condensation on a Short Vertical Plate

Numerical Simulation of Condensation for R410a in Horizontal Round and Flattened Minichannels

Condensation in Horizontal Smooth Tubes: A New Heat Transfer Model for Heat Exchanger Design

Dropwise Evaporative Cooling of Heated Surfaces with Various Wettability Characteristics Obtained by Nanostructure Modifications