Abstract:YBCO bulks with submicron Y2BaCuO5 particles have been prepared under oxygen partial pressures of 0.21atm and 1atm, respectively, by the powder melting process (PMP). The microstructures, oxygen contents and critical current densities of the samples have been investigated. The results showed that the sample grown under P(O2) = 1 atm contained Y2BaCuO5 particles with a little bigger average size and had a slightly higher density of stacking faults than the one prepared under P(O2) = 0.21 atm. Oxygen content measurements indicated that the as-grown sample under P(O2) = 1 atm had a higher oxygen content. After post-annealing in flowing oxygen, the oxygen content of the P(O2) = 1 atm sample was still higher than that of the P(O2) = 0.21 atm sample. They were examined to be 6.94 and 6.88 with X-ray diffraction for the two oxygenated samples, respectively. Magnetization measurements have been performed on the two types of oxygenated samples and critical current densities (Jc) have been calculated based on the extended Bean critical state model. The P(O2) = 0.21 atm sample exhibits Jc values of 5.47×105 A/cm2 and 2.22×104 A/cm2 in 1 T magnetic field at 20K and 77K, respectively. The P(O2) = 1 atm sample, meanwhile, has Jc values of 9.46×105 A/cm2 and 1.47×104 A/cm2 in 1 T magnetic field at 20K and 77K, respectively. Moreover, at 20K, the Jc of the P(O2) = 1 atm sample is higher than that of the P(O2) = 0.21 atm sample in an applied magnetic field up to 5 T. At 77K, however, the Jc of the P(O2) = 1 atm sample drops more quickly than that of the P(O2) = 0.21 atm sample. The mechanisms of the different microstructures, oxygen contents and magnetic field dependence behaviors of Jc for the two kinds of samples have been discussed.

Investigation of Ybco Single Crystals Grown under 1 Atm Oxygen Pressure and Air Atmosphere

Fabrication of Large YBCO Single Crystal by SRL-CP Method under 1 atm Oxygen Pressure

Enhanced Growth Rate of a YBCO Bulk in the Melt-Textured Process under 1 Atm Oxygen Pressure

Enhancement of Ybco Thin Film Thermal Stability under 1 Atm Oxygen Pressure by Intermediate Cu2o Nanolayer

Effect of Pulling Rates on Quality of La2−xBaxCuO4 Single Crystal

Crystal Growth of A High-T-C Smbco Superconductor in 1 Atm Oxygen Pressure

Single Crystals Sr14-xCaxCu24O41 Grown under Different Oxygen Pressures by Optical Floating-Zone Technique

Influence of Oxygen Partial Pressure on the Microstructures and Critical Current Densities of PMP-Processed YBCO Bulks with Submicron Y2BaCuO5 Particles

Dominant Effect of Oxygen Enhancement on the Crystalline Orientation of Yba2cu3ox Film Prepared by Liquid-Phase Epitaxial Growth

Electrical Properties of Yttrium Calcium Oxyborate Crystal Annealed at High Temperature and Low Oxygen Partial Pressure

Large-Sized Smbco Single Crystals With T-C Over 93 K Grown In Atmospheric Ambient By Crystal Pulling

Precisely Determined Temperature Window Size for the Growth of High Quality C-Axis Oriented Ybco Films by Photo-Assisted Mocvd

Growth and properties of superconducting YBCO single crystals

Crystal growth and characterization of the quasi-one-dimensional compound BaCoO3

High Pressure RHEED Study on the Initial Structure and Growth Dynamics of Y Ba2Cu3O7−δ Thin Films on SrTiO3 (001)

Modulus Study of Microcracks in Single Domain YBa2Cu3Ox with C-Axis Pressure During Oxygen Anneal

Structural Stability and Electro-Elastic Property of YCOB Crystal Annealed in Harsh Environment

Preferential Growth and Peculiar Interfacial Atomic Configuration of the YBCO Liquid-Phase Epitaxial Film with 45° In-Plane Alignment

The Effects of Chemical Doping and Hydrostatic Pressure on Tc of Y(1-y)CayBa2Cu3Ox and NdBa2Cu3Ox Single Crystals

Influence of O2 Pressure on the Structure and Surface Morphology of YSZ Layer for YBCO Coated Conductor Deposited by PLD on Ni-W Tape

Pressure-induced yttrium oxides with unconventional stoichiometries and novel properties