Study on the Regulation Boundary for Two-Stage Turbocharging System at Different Altitudes
Huiyan Zhang,Hualei Li,Mengyu Li,Lei Shi,Kangyao Deng
DOI: https://doi.org/10.1115/gt2017-63923
2017-01-01
Abstract:Regulated two-stage (RTS) turbocharging system is an effective way to enhance power density and reduce pollutant of internal combustion engine for increasingly stringent demands of fuel consumption and emission regulation. Due to achieving high boost pressure with great system efficiency and controllable characteristic in wide working range, the RTS turbocharging system improves output power at low speed condition and reduces pumping loss at high speed condition. Composing of two turbochargers and control valves, the RTS turbocharging system is matched with engine at a design point and regulated by adjusting control valves to meet the engine requirement of intake pressure and flow at other working conditions. Calibration of the control valves under all operating conditions by plentiful experiments is significant for turbocharging system, particularly that matched with diesel engine for vehicle. Moreover, when an automobile run on the plateau, the intake air flow will decrease and combustion in cylinder will deteriorate obviously. Compared with other turbocharging system, two-stage turbocharging system is more suitable to the offset power loss of engine. Regulating boost system under different operation conditions draws more attention to engine performance recovery so that the workload of calibration raises rapidly in consideration of altitude factor. Though much work has been done in calibration at various altitudes, there are few, if any, discussion on open-closed boundary of control valves to simplify the calibration process. In this paper, it aims to present a regulation boundary model of control valve at different altitudes to guide the calibration and a series of experiments for RTS system can be saved. Firstly, a thermodynamics analysis of the RTS turbocharging system is conducted and typical regulation methods are compared in terms of the adjustment capacity and efficiency characteristics of turbocharging system, which indicates that high-stage turbine bypass is the optimum regulation method. Then, a regulation boundary model for the RTS turbocharging system at different altitudes is deduced, according to the relation of equivalent turbine area and engine operating condition. The regulation boundaries of different altitudes are obtained by iterative computation of the model, and the whole working mode of the RTS system is divided into a fully closed area and a regulated area. Experiments are carried out to verify the regulation boundary model at sea level condition. Brake torque, efficiency of the RTS system and temperature before high-stage turbine are primary parameters for verification in this article. The maximum error shows up with a value of 3.65% brake torque at 2200rpm. While a one-dimensional simulation model is built up to validate the regulation boundary model of the plateau. All the errors are smaller than 3% at various altitudes. It results that model is accurate enough to predict the regulation boundary of the RTS system. By the calculation of regulation boundary model, the brake torque at regulation boundary will decrease if the engine speeds up. It also manifests that fully closed area will argument if the automobile climbs up to high operating altitude, especially under high speed condition.