NITROGEN REMOVAL USING ATTACHED IMMOBILIZED ANAMMOX SLUDGE ON PVA GEL BEADS
Hoang Thi Thu Hien,Zhijun Liu,Khanh Luong Ngoc,K. Furukawa
2004-10-15
Abstract:INTRODUCTION Ammonium-rich wastewaters are produced normally from the food processing, agricultural industries. Therefore, nitrogen pollution has become the attractive problem of scientists in recently. The current method of removal of ammonium in wastewater treatment plants consists of a combination of aerobic nitrification catalyzed by autotrophic nitrifiers and anoxic denitrification catalyzed by heterotrophic denitrifiers. In the nitrification process, ammonium is oxidized to nitrate via nitrite, and nitrate is reduced with organic carbon via nitrite to N2 in denitrification process. This combination was considered as the only economical way to remove ammonium from wastewater. However, more economical considerations using shortcuts in the nitrification-denitrification process, i.e., Anaerobic Ammonium Oxidation (Anammox), was attracted much attentions. When the Anammox process is combined with the nitritation step, the remaining ammonium and the converted nitrite from nitritation will be oxidized to yield nitrogen gas under anoxic conditions with nitrite as the electron acceptor. This autotrophic process allows over 50% saving of the oxygen and no organic carbon supplementation for denitrification. In addition, the biomass yield is very low for Anammox bacteria, so that little sludge is produced in Anammox process. The stoichiometry of the Anammox reaction was determined as follows: NH4 + 1.32 NO2 + 0.066 HCO3 + 0.13H → 1.02 N2 + 0.26 NO3 + 0.066 CH2O0.5N0.15 + 2.03 H2O In this research, PVA gel beads was selected as biomass carriers for Anammox sludge and applied for fluidized bed reactor. The objectives of this research were to evaluate the ammonium removal capabilities of Anammox sludge in fluidized bed reactor using PVA gel beads.
Environmental Science,Chemistry