Abstract:The primary objective of this study is to investigate the potential of using microscopic simulation models and Surrogate Safety Assessment Model (SSAM) for evaluating the safety performance of signalized intersections. A widely used microscopic simulation package VISSIM was used in this study to develop simulation models. The validity of using VISSIM and SSAM for traffic safety analysis at signalized intersections was tested by comparing the simulated conflicts to those measured in the field using traditional traffic conflicts techniques. Of particular interest was to identify if the consistency between simulated and observed conflicts could be improved by calibrating VISSIM simulation models and adjusting threshold values used for defining simulated conflicts in SSAM. A two-stage procedure was proposed in this study to develop, calibrate and validate VISSIM simulation models. It was found that the two-stage calibration procedure greatly improved the goodness-of-fit between simulated conflicts and real-world conflicts. After model calibration, the mean absolute percent error (MAPE) for total conflicts was reduced from 44% to 24%. More specifically, the MAPE value was reduced from 26% to 15% for rear-end conflicts, from 69% to 29% for crossing conflicts, and from 83% to 81% for lane-change conflicts. Linear regression models and the spearman rank correlation coefficient were also developed to study the relationship between simulated conflicts and observed conflicts. Data analysis results showed that there was a reasonable goodness-of-fit between simulated and observed rear-end and crossing conflicts. However, it was also found that the simulated conflicts generated by VISSIM and SSAM are not good indicators for traffic conflicts which are generated by unexpected driving maneuvers such as illegal lane-changes in the real world.

Level of safety service for highway signalized intersections

The Quantitative Analysis of the Level of Service of Two-lane Highways Based on Overtaking Ratio

Development of a Procedure for Using Surrogate Safety Assessment Model and VISSIM for Safety Assessment at Signalized Intersections

A New Evaluation Method Combining Efficiency and Safety: Multimodal Comprehensive Level of Service of Signalized Intersections

Modeling level-of-safety for bus stops in China

An evaluation system for signalized intersections in a mixed-traffic environment

Evaluation Index and Methods of Highway Intersection Safety Maintenance

Level of Service Model of the Non-Motorized Vehicle Crossing the Signalized Intersection Based on Riders’ Perception Data

Influence of signal on the capacity of signalized intersection

A Heckman Selection Model for the Safety Analysis of Signalized Intersections

Research on Reliability of Signalized Intersections Based on Monte-Carlo Numerical Simulation

Critical Traffic Volume Warrant of Signal Installing at Equal Weight Intersections

Inter-green interval calculation for signalized intersections

A Group-Based Signal Timing Optimization Model Considering Safety for Signalized Intersections with Mixed Traffic Flows

Critical Traffic Volume of Traffic Signal Warrant at Major-Minor Intersections

Safety Evaluation for Expressways: A Comparative Study for Macroscopic and Microscopic Indicators

Level of Service Evaluation Method for Waterway Intersections

Bicycle and Pedestrians' Arrival and Departure Characteristics at Signalized Intersection

Evaluation and Simulation Study of Traffic at Intersection of Wuhan Heping Avenue-Jianshe No.2 Road

Development of a Safety Evaluation Model for Provincial Highway

Prediction of User Perceptions of Signalized Intersection Level of Service Based on Fuzzy Neural Networks