Calculation Analysis of the Thermotechnical Parameters of a Waste-heat Power Generation System in a 5000 t/d Dry-method Cement Production Line
DONG Chen,ZHAO Qin-xin,ZHOU Qu-lan,Tongmo Xu
2009-01-01
Abstract:For a 5 000 t/d new type dry-method cement kiln system,a pure low-temperature dual-pressure waste-heat power generation system was designed,and a theoretical calculation analysis of various parameters of the system,performed.Obtained was a law governing the influence on the power generated by the system by the following items:main steam temperature and pressure,feedwater temperature,high-pressure node temperature difference and approach point temperature difference,low-pressure steam temperature and pressure,low-pressure node temperature difference and approach point temperature difference as well as system feedwater temperature within the system mentioned earlier.The calculation results show that a relatively large number of factors have a bearing on the power generated by the cement kiln waste-heat power generation system.When a waste-heat power generation system is being designed,its power generated and cost-effectiveness should be comprehensively considered in order to choose optimum parameters.Among the various operating conditions being calculated,i.e.when for the waste-heat recovery steam generator at the tail portion of the kiln the main steam temperature is 300 ℃,the main steam absolute pressure,1.6 MPa,feedwater temperature,170 ℃,both high and low pressure node temperature differences,15 ℃,and both the high and low pressure approach point temperature differences,11 ℃,the low-pressure steam temperature of the heat-recovery steam generator at the head of the kiln,180 ℃,low-pressure steam absolute pressure,0.25 MPa,the system feedwater temperature,50 ℃,and the back pressure of the steam turbine,8 kPa,to sum up,under the condition of all the above items,the power generated by the system will be maximal,reaching 13 791.878 kW.