Abstract:Purpose - This paper aims to present the slip/no-slip design in two-dimensional water-lubricated tilting pad thrust bearings (TPTBs) considering the turbulence effect and shifting of pressure centers. Design/methodology/approach - A numerical model is established to analyze the slip condition and the effect of turbulence according to a Reynolds number defined in terms of the slip condition. Simulations are carried out for eccentrically and centrally pivoted bearings and the influence of different slip parameters is discussed. Findings - A considerable enhancement in load capacity, as well as a reduction in friction, can be achieved by heterogeneous slip/no-slip surface designs for lubricated sliding contacts, especially for near parallel pad configurations. The optimized design largely depends on the pivot position. The load capacity increases by 174 per cent for eccentrically pivoted bearings and 159 per cent for centrally pivoted bearings for a suitable design. When slip zone locates at the middle of the radial direction or close to the inner edge, the performance of the TPTB is better. Research limitations/implications - The simplification of slip effect on the turbulence (definition of Reynolds number) can only describe the trend of the increasing turbulence due to slip condition. The accurate turbulence expression considering the boundary slip needs further explorations. Originality/value - The shifting of pressure center due to the slip/no-slip design for TPTBs is investigated in this study. The turbulence effect and influence of slip parameters is discussed for large water-lubricated bearings.

A Three-Dimensional TEHD Model and an Optimum Surface Profile Design of Pivoted Pad Thrust Bearings With Large Dimensions

Three-dimensional TEHD Analysis of Bi-directional Thrust Bearing in Pump-turbine

Thermo-elastohydrodynamic Lubrication Analysis on Multi-tilting-pad Journal Bearing

Multiphysics TEHD Model of a Tilting-Pad Thrust Bearing with Polymeric Layer

Optimum Design of Permanent Magnet Thrust Bearings Based on Current Sheet Model

Design and Fabrication of the Tilting-Pad Thrust Bearing Surface Profile

Experimental Study on Multi-Decked Protuberant Foil Thrust Bearing with Different Number of Thrust Pads

Influences of Manufacturing Tolerances on Thermo-elastohydrodynamic Lubrication Performance of Multi-tilting-pad Journal Bearing

Investigation of Slip/no-Slip Surface for Two-Dimensional Large Tilting Pad Thrust Bearing

Study on the thermoelastohydrodynamic performance of tilting-pad bearings for large-scale power units

Thermoelastohydrodynamic Analysis of the Static Performance of Tilting-Pad Journal Bearings with the Newton–Raphson Method

Performance Comparison of Circular, Two-Lobe and Elliptical Journal Bearings Based on Tehd Analysis

3D Two-Way Coupled Tehd Analysis on the Lubricating Characteristics of Thrust Bearings in Pump-Turbine Units by Combining Cfd and Fea

Numerical Optimization of the Groove Texture Bottom Profile for Thrust Bearings

Multiphysics Modeling of a Tilting Pad Thrust Bearing: Comparison Between White Metal and Polymeric Layered Pads

Theoretical and Experimental Study on the Static and Dynamic Characteristics of Tilting-Pad Thrust Bearing

Thermo-hydrodynamic analysis of large-eccentricity hydrodynamic bearings with texture on journal surface

Effects of support structure on lubricating properties of bi-directional thrust bearings

Study on the Water Lubricated Large-scale Tilting Pad Thrust Bearing by Finite Element Method

Optimization transient wear and contact performances of water-lubricated bearings under fluid-solid-thermal coupling condition using profile modification

CFD analysis for static and dynamic characteristics of hydrodynamic thrust bearings