Abstract:An accelerator-based neutron irradiation facility (ANIF), which has been proposed for BNCT, is based on a 2.5-MeV proton beam bombarding a thick lithium target. Neutrons which are emitted from the lithium target are too energetic for BNCT and must be moderated. A calculational study, which was done previously on the moderator assembly for an ANIF, shows that, with an optimized moderator assembly, an ANIF can produce a neutron flux which has quality and intensity sufficient for BNCT. In order to verify our previous calculational study, a lithium target and a non-optimized moderator assembly (a cylindrical tank of D2O) have been constructed and tested at the Ohio State University Van de Graaff proton accelerator. The neutron spectrum was measured for neutrons emerging from the moderator assembly. The measured neutron spectrum agrees reasonably well with that obtained from Monte Carlo calculations, except for neutrons with energies above 100 keV. For those neutrons, the measured spectrum is lower by a factor of two than the calculated one. In addition to the neutron spectrum measurement, the boron-10 absorbed dose was measured on the axis of the neutron field in a 20 cm x 20 cm x 20 cm water phantom, and the result agrees quite well with that obtained from calculation. This experiment confirms that the calculated optimized moderator assembly, consisting of a 22.5-cm thick, 25-cm diameter cylinder of beryllia (BeO) surrounded by a 30-cm thick jacket of alumina (Al2O3), produces an epithermal neutron flux of 3.12 x 10(7) n/cm2-s per mA of protons. For an accelerator delivering 30 mA of 2.5-MeV protons, the irradiation time for a single-session treatment can be as short as 50 minutes. The calculated ratio of absorbed neutron dose to fluence for the optimized moderator assembly is 4.9 x 10(-11) cGy-cm2/n, which is equal to that of a 5-keV neutron beam. Our experimental measurements indicate that the ratio of absorbed neutron dose to fluence may in fact be lower (better) than calculated.

Neutron Moderation and Collimation of a D-Be Neutron Source Based on a High Current Accelerator

Laser-Driven Collimated Neutron Sources Based on Kinematic Focusing

Design of moderator and collimator based on compact D-T neutron source for neutron imaging

A compact moderator for thermal neutron reference radiation field with an 241Am-Be source

Design of Moderator Assemblies for Fast, Epithermal, or Thermal Neutron–Dominated n-γ Mixed Fields Using a D-D Neutron Source

General guide concepts for compact, high-brilliance neutron moderators

An experimental study of the moderator assembly for a low-energy proton accelerator neutron irradiation facility for BNCT

Optimization design for moderator, reflector, and shielding of Deuterium-Deuterium neutron source

Neutron Yields of Thick Be Target Bombarded with Low Energy Deuterons

Design of a mixed material moderator in a beam-shaping assembly for proton accelerator-based boron neutron capture therapy

A compact accelerator-driven deuterium–deuterium neutron source using heavy water jet target

Neutron collimator design of neutron radiography based on the BNCT facility

Experimental study on neutro radiography with accelerator based neutron source using D-BE reaction

Low dimensional neutron moderators for enhanced source brightness

Simulation and Analysis of Photo neutron's Characteristics Driven by 150 MeV Electron Beam

Conceptional design of an adjustable moderator for BNCT based on a neutron source of 2.8 MeV proton bombarding with Li target

Beam-induced Back-streaming Electron Suppression Analysis for Accelerator Type Neutron Generators

Study on collimation and shielding of the back-streaming neutrons at the CSNS target

Neutron energy spectra from accelerator-based thick target 9Be(d,n) reaction using CR-39 stacks

Study of Flow and Heat Transfer for the Supercritical Hydrogen in Spallation-Type Cylindrical Neutron Moderator