Stability analysis of intermittently jointed rock slopes based on the stepped failure mode
DOI: https://doi.org/10.1007/s11629-023-8192-5
IF: 2.371
2024-03-24
Journal of Mountain Science
Abstract:In practical engineering, due to the noncontinuity characteristics of joints in rock slopes, in addition to plane failure, stepped sliding failure may occur for intermittently jointed rock slopes. Especially for intermittently bedding jointed rock slopes, the correlation and difference in strength parameters between joints and rock bridges, along with the various failure modes and intermittency of rock bridges, contribute to the complexity of stepped failure modes and the unpredictability of failure regions. Based on the upper-bound limit analysis method and multi-sliders step-path failure mode, considering the shear and tensile failure of rock bridges and the weakened relationship between the strength parameters of rock bridges and jointed surfaces, by introducing the modified M-C failure criterion and the formula for calculating the energy consumption of tensile failure of rock bridges, two failure mechanisms are constructed to obtain the safety factor ( F s ) of intermittently jointed rock slopes. The sequential quadratic programming method is used to obtain the optimal upper-bound solution for F s . The influence of multiple key parameters (slope height H , horizontal distance L , Slope angle β , shear strength parameters of the rock bridge φ r and c r , Dimensionless parameter u , weakening coefficients of the internal friction angle and cohesion between the rock bridges and joint surfaces K φ and K c ) on the stability analysis of intermittently jointed rock slopes under the shear failure mode of rock bridges as well as under the tensile failure mode is also explored. The reliability of the failure mechanisms is verified by comparative analysis with theoretical results, numerical results, and landslide cases, and the variation rules of F s with each key parameter are obtained. The results show that F s varies linearly with φ r and c r of the rock bridge and with K φ and K c , whereas F s changes nonlinearly with H and L . In particular, with the increase in K φ and K c , F s increases by approximately 52.78% and 171.02% on average, respectively. For rock bridge tensile failure, F s shows a nonlinearly positive correlation with φ r , c r , K φ and K c . In particular, with the increase in K φ and K c , F s increases by approximately 13% and 61.69% on average, respectively. F s decreases rapidly with increasing slope gradient β and decreasing dimensionless parameter μ . When K φ </sub -Abstract Truncated-
environmental sciences