Abstract:A novel three-dimensional (3D) hierarchical structure and a roughly oriented one-dimensional (1D) nanowire of WO3 are selectively prepared on an alumina substrate by an induced hydrothermal growth method. Each hierarchical structure is constructed hydrothermally through bilateral inductive growth of WO3 nanowire arrays from a nanosheet preformed on the substrate. Only roughly oriented 1D WO3 nanowire can be obtained from a spherical induction layer. The analyses show that as-prepared 1D nanowire and 3D hierarchical structures exhibit monoclinic and hexagonal phases of WO3, respectively. The gas-sensing properties of the nanowires and the hierarchical structure of WO3, which include the variations of their resistances and response times when exposed to NO2, are investigated at temperatures ranging from room temperature (20 °C) to 250 °C over 0.015 ppm–5 ppm NO2. The hierarchical WO3 behaves as a p-type semiconductor at room temperature, and shows p-to-n response characteristic reversal with the increase of temperature. Meanwhile, unlike the 1D nanowire, the hierarchical WO3 exhibits an excellent response characteristic and very good reversibility and selectivity to NO2 gas at room temperature due to its unique microstructure. Especially, it is found that the hierarchical WO3-based sensor is capable of detecting NO2 at a ppb level with ultrashort response time shorter than 5 s, indicating the potential of this material in developing a highly sensitive gas sensor with a low power consumption.

Microstructure Characterization and NO2-sensing Properties of Tungsten Oxide Nanostructures

Synthesis and NO2-sensing Properties of One-Dimensional Tungsten Oxide Nanowire Bundles

Low-temperature NO2-sensing Properties and Morphology-Controllable Solvothermal Synthesis of Tungsten Oxide Nanosheets/nanorods

Solvothermally Synthesized Tungsten Oxide Nanowires/Nanorods for No2 Gas Sensor Applications

Effect of annealing on microstructure and NO2-sensing properties of tungsten oxide nanowires synthesized by solvothermal method

Preparation of 2 Nm Tungsten Oxide Nanowires Based on Two-Phase Strategy and Their Ultra-Sensitive NO2 Gas Sensing Properties

Solvothermal Synthesis of Wo3 Nanocrystals with Nanosheet and Nanorod Morphologies and the Gas-Sensing Properties

WO3 Nanosheet/W18O49 Nanowire Composites for NO2 Sensing

Synthesis Of Tungsten Oxide Nanowires/Porous Silicon Composite And Its Sensing Properties For No2

Facile Synthesis and NO2 Gas Sensing of Tungsten Oxide Nanorods Assembled Microspheres

Morphology-controlled Preparation of Tungsten Oxide Nanostructures for Gas-Sensing Application

Synthesis mechanism and gas-sensing application of nanosheet-assembled tungsten oxide microspheres

Room Temperature NO2-sensing Properties and Mechanism of the Sensors Based on Tungsten Oxide Nanowires/single-Wall Carbon Nanotubes Composites

Synthesis and Low-Temperature Gas Sensing Properties of Tungsten Oxide Nanowires/Porous Silicon Composite

Ionic liquid-assisted synthesis of tungsten oxide nanoparticles with enhanced NO<sub>2</sub> sensing properties at near room temperature

Influence of Synthesis Conditions on Microstructure and NO2 Sensing Properties of WO3 Porous Films Synthesized by Non-Hydrolytic Sol–Gel Method

Hydrothermal Synthesis Porous Silicon/Tungsten Oxide Nanorods Composites and Their Gas-Sensing Properties to No2 at Room Temperature

Room Temperature NO2-sensing Properties of Ti-added Nonstoichiometric Tungsten Oxide Nanowires

Highly Sensitive NO2 Sensor Based on Square-Like Tungsten Oxide Prepared with Hydrothermal Treatment

Preparation of Wo3 Nanoparticles and Application to No2 Sensor

Mesostructured WO3 as a sensing material for NO2 detection