Abstract:Summary form only given. The dielectric barrier discharge (DBD) in air at atmospheric pressure was investigated with electrical measurement and fast photography. Homogeneous DBD without filaments was obtained in a gap of a length as long as 3 mm, which has never been reported in previous literatures. The air gap was in between two plane-parallel electrodes of 50 mm in diameter, each covered by a specific ceramic plate with a thickness of 1.5∼3.25 mm. By subtracting the displacement current from the total current, there appears one current peak per half cycle of the applied sinusoidal voltage, which is typical for homogeneous DBD. The current peak is 1 mA in amplitude and about 85 µs in FWHM (full width at half magnitude). Side-view photographs with 10 ns exposure time taken at the time about the peak of the current pulse showed that there were no filaments in the discharge gap. A luminous layer close to the instantaneous anode was observed, indicating the homogeneous DBD was a Townsend discharge. When choosing a ceramic thinner than 1.5 mm, some filaments randomly appeared in the gap, as was called a mixed mode of homogenous and filamentary DBD. This was because in DBD the dielectric capacitance played an important role in the limitation of the discharge current. A smaller capacitance would help to avoid an electron avalanche overdeveloping to a streamer. When a stable Townsend discharge was maintained, the breakdown voltage was determined to be only 8.3 kV, much lower than the static breakdown voltage of 11.2 kV for the same air gap of 3 mm in length. The formation of Townsend discharge was attributed to the uniqueness of the shallow traps on the surface of the specific ceramic plate and the common effect of the current limitation by dielectric.

Realization of Homogenous Discharge at Atmospheric Pressure in Air Using Wire Mesh Covered by Pet Films

Study of Homogeneous DBD with Fine Wire Meshes and PET Films in Air at Atmospheric Pressure

Surface Treatment by Dielectric Barrier Discharge with Wire Mesh Electrodes

Study on the atmospheric pressure homogeneous discharge in air assisted with a floating carbon fibre microelectrode

Modification of terylene fabric by homogeneous discharge in air at atmospheric pressure

Influence of Wire Mesh Electrodes on Dielectric Barrier Discharge

A Comparative Study of Water Electrodes Versus Metal Electrodes for Excitation of Nanosecond-Pulse Homogeneous Dielectric Barrier Discharge in Open Air

The Transition Of Surface Charge During Partial Discharge Sequences Under Low Pressure

Generation of Large-Area and Glow-Like Surface Discharge in Atmospheric Pressure Air

Diffuse and Filamentary Discharges in Open Air Driven by Repetitive High-Voltage Nanosecond Pulses

A Homogeneous Atmospheric Pressure Air Plasma in a 10 Mm Gap Based on a Three-Electrode Configuration

Effect of Airflows on Repetitive Nanosecond Volume Discharges

The Transition of Partial Discharge to Homogeneous Discharge in Nitrogen at Low Pressure

Influence of Residual Charge on Repetitively Nanosecond Pulsed Dielectric Barrier Discharges in Atmospheric Air

Nanosecond Repetitively Pulsed Discharge of Point–Plane Gaps in Air at Atmospheric Pressure

Repetitive Nanosecond-Pulse Discharge in Tip-Grid Gaps in Atmospheric Air

Study of Dielectric Barrier Townsend Discharge in Air at Atmospheric Pressure

Experimental study of homogeneous dielectric barrier discharge in air at atmospheric pressure

Atmospheric Pressure Glow Discharge in Air Using A Water Electrode

Atmospheric Pressure Glow Discharge in Air by Decreasing Electric Field During the Discharge

Large-Area Cold Atmospheric Pressure Discharges Realized by Mesh Covered Tube-Plate Electrodes in Open Air