Abstract:Achieving high data rate with simple system configuration and low power consumption is of great interest in short-reach intensity-modulation direct-detection (IM-DD) fiber links for future datacenter networks, business local area networks and so forth. For external modulation-based IM-DD, recently remarkable modulator performance has been achieved in terms of 3dB bandwidth, exploiting different materials/platforms. However, due to the relatively-high RF-to-RF (or end-to-end) signal loss, optical amplifiers (OA) and/or RF amplifiers (RFA) were typically needed for IM-DD links, which increases the complexity and power dissipation. In this work, we present a more comprehensive figure of merit (FoM) for modulator (and link) design, namely “slope efficiency (SLE)”, which takes into account not only the bandwidth but also the half-wave voltage and the RF/optical waveguide losses, and can provide a guiding principle of the modulator design toward lower RF-to-RF signal loss. With a high-SLE modulator, both OA and RFA can be omitted even when supporting broadband signals with CMOS-level driving voltages. We theoretically investigate the impact of modulators with different technology and SLE on the IM-DD pulse amplitude modulation (PAM) link. Next, we report a series of PAM transmission experiments with a high-SLE Lithium Niobate intensity modulator prototype, which enables sub-1Vpp driving, up-to-432Gb/s PAM transmission over up-to-600m single-mode fiber in C-band with OA&RFA-free reception and low digital signal processing (DSP) complexity. For instance, for 384Gb/s PAM8 over 300m, the transmitter was DSP-free while a symbol-spaced decision-feedback equalizer (DFE) with 61 feedforward taps and 1 feedback tap was sufficient for the receiver considering 16.7% hard-decision (HD)-FEC. Furthermore, we experimentally show that the high-SLE modulator supports ultra-wide fiber transmission bands (O-, S-, C- and L-band).

High-frequency Characterization of an Optical Phase Modulator with Phase Modulation-to-intensity Modulation Conversion in Dispersive Fibers

Instantaneous Microwave Frequency Measurement Using an Optical Phase Modulator

Simultaneously Realizing PM-IM Conversion and Efficiency Improvement of Fiber-Optic Links Using FBG

Tunable Fiber Fabry‐perot Filter for PM‐IM Conversion and Efficiency Improvement in Radio‐over‐fiber Links

Photonic Instantaneous Microwave Frequency Measurement Based on Two Different Phase Modulation to Intensity Modulation Conversions

Phase modulation depth setting technique of a phase-generated-carrier under AOIM in fiber-optic interferometer with laser frequency modulation.

Microwave Frequency Measurement Based on Phase Modulation to Intensity Modulation Conversion Using Fiber Bragg Grating

Highly Efficient Silicon Michelson Interferometer Modulators

Measurement of Polarization Mode Couplings in Polarization-Maintaining Fibers Based on White Light Interference

A Photonic Approach for Doppler Frequency Shift Measurement with Dispersion Medium

Photonic Instantaneous Frequency Measurement with Digital Output Based on Dispersion Induced Power Fading Functions

A PM-based Approach for Doppler Frequency Shift Measurement and Direction Discrimination

Residual Third-Order Dispersion Compensation in Femtosecond Pulses Transmission Using a Phase Modulator

Measurement of the phase shift between intensity and frequency modulations within DFB-LD and its influences on PGC demodulation in a fiber-optic sensor system.

Novel Demodulation Method for Fiber-Optic Interferometers Based on $\pi/2$ Phase Modulation

Half-Wave Voltage Measurement Method Based on SI and Time-Domain Pulse Intensity Demodulation

High-Stability PGC Demodulation Algorithm Based On a Reference Fiber-Optic Interferometer With Insensitivity to Phase Modulation Depth

An Alternative Phase Modulator Half-Wave Voltage Measurement Based on Photonic Link

A High-Performance Multistep Phase-shifting Interferometric Fiber Optic Sensing Method with Modulation Error Correction Capability

High-Speed Low-Complexity Optical PAM Links With a High-Slope-Efficiency Optical Modulator: Analysis and Demonstration

Dispersion monitoring based on self phase modulation and cross phase modulation effects in semiconductor optical amplifier