Abstract:The particle size distribution (PSD) and particle morphology of metal powders undoubtedly affects the quality of parts produced by additive manufacturing (AM). It is, therefore, crucial to accurately know the PSD and morphology of these powders. There exist several measurement techniques for these quantities, but since each method is based on different physical phenomena, which are sensitive to different aspects of a particle's shape and size, it is unclear how the measured PSDs and morphology compare to one another. In this study, five different techniques are used: sieve analysis, dynamic imaging analysis, laser diffraction analysis, X-ray computed tomography (XCT), and scanning electron microscopy. The first three are commonly used in the powder metallurgy field while the last two are laboratory-based tools capable of providing robust size and shape data. Nominally identical samples of stainless-steel powders were produced via riffling, and each technique was employed to measure effectively the same PSD and in some cases the morphology. In this paper, the differences among these measurement techniques are explored by a comparison of the measured results. Besides the random variations of the various measurement processes, the difference in the results is partly due to the fact that the particles are not perfectly spherical and that there are many multi-particles present. Each of these affect the principle of each method differently. Three-dimensional particle morphology and size data collected via XCT is used to provide insight regarding the discrepancies among other sizing and morphology measurement techniques. (Official contribution of the National Institute of Standards and Technology; not subject to copyright in the United States.)

Design and Research of In-process Particle Size Measurer

Determination of Particle Size Distribution by Multi-Scale Analysis of Acoustic Emission Signals in Gas-Solid Fluidized Bed

Measurement of Particle Materials and Liquid Level

Research on representation of particle size distribution for standard sands

Integrated method of wavelet packet analysis and K-OPLS and its application in measurement of particle size distribution

A New Particle Sensor Based on True RMS Value Measurement.

A dual-probe three-dimensional profile measurement system

Numerical Investigation on Sample Population Requirement for Mean Particle Diameter Analysis

Digital Holographic Sizer for Coal Powder Size Distribution Measurement: Preliminary Simulation and Experiment

A comparison of particle size distribution and morphology data acquired using lab-based and commercially available techniques: Application to stainless steel powder

Experimental Investigation of the Sedimentation Behavior of Metal Droplets in Liquid–liquid Systems

Dual-beam Interferometric Particle Imaging for Size and Shape Characterization of Irregular Coal Micro-Particle: Validation with Digital Inline Holography

3D Locating and Sizing of Volumetric Metal Droplets with Astigmatic Dual-Beam Interferometric Particle Imaging at Panoramic Scattering Angle

Dissecting PM sensor capabilities: A combined experimental and theoretical study on particle sizing and physicochemical properties

Measurement and Simulation Validation of DEM Parameters of Pellet, Sinter and Coke Particles

Development of Three Configurations of Dual-Beam Interferometric Particle Imaging for Opaque Metal Droplet Size Measurement

Development of a DEM Method for Predicting Wear Distribution on Particle Scale

Embedded Particle Size Measurement Method of Metal Mineral Polished Section Using Gaussian Mixture Model Based on Expectation Maximization Algorithm

Dual-beam Interferometric Particle Imaging for Size Measurement of Opaque Metal Droplet

Metal Powder Production and Powder Size and Shape Distribution

Development of particle size and shape measuring system for machine-made sand