Abstract:Research on FE method simulation of CMT+P MIX welding process has been suspended because of the absence of qualified model for characterizing cooperation between wire feeding and heat input. A novel 3D FE thermo-mechanical model was established, in which impulse input of weld wire and weld heat was simplified by decreasing the impulse frequency. Materials were modeled as elastic-perfectly-plastic with composite heat sources utilized. Numerically simulated results were validated by thermal cycle curves and residual stress distribution obtained with infrared photography instrument and X-ray diffraction tester, respectively. The numerical residual stress distribution also got well supported by the tested results obtained by the blind-hole method. Residual stress evolution was analyzed, whereas special attention was paid to the influences on residual stress distribution by the subsequent weld passes. Based upon this was the vulnerable area of the joint identified under the conduction of different strength theories. The global stress distribution was found to be dominated by the first weld pass while more residual stress in the re-melted zone than that in the HAZ could be released by the last two welding passes. The mechanism was studied through the yielding process of residual strain which was divided into two steps.

Discussion and calculation on welding residual longitudinal stress and plastic strain by finite element method

Calculation and Discussion of Welding Stress and Strain Field

Calculation and Discussion of Welding Plastic Strain

Analysis and discussion on welding residual stress and strain

Effect of Welding Residual Stress on Plastic Buckling of Axially Compressed Cylindrical Shells with Patterned Welds

Three-dimensional finite element analysis on welding residual stresses of construction steel

Effect of Thermophysical Parameters on the Hump Feature of Welding Residual Stress by Finite Element Analysis

Review on finite element analysis of welding deformation and residual stress

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Fundamental research of welded plastic strain evolution process II: Evolution process of welded plastic strain in thin stainless steel plate

Investigation of Residual Stress in Butt-Welded Plates Considering Phase Transformation

Finite element and experiment analysis of welding residual stress in S355J2 steel considering the bainite transformation

3D-FEM numerical simulation of welding stress in thin aluminum alloy plate

Fundamental research of welding plastic strain evolution process: Characteristics and law of evolution process of welding plastic strain in mild steel, stainless steel and titanium alloy thin plate

Numerical investigation on residual stress distribution and evolution during multipass narrow gap welding of thick-walled stainless steel pipes

Welding residual stress analysis of the X80 pipeline: simulation and validation

Efficient Calculation Technologies for Welding Stress and Deformarion with Nonlinear and Gradient Character

A review of residual stress effects on fatigue properties of friction stir welds

ANALYSIS OF THERMAL ELASTIC-PLASTIC STRESS AND STRAIN DURING WELDING BY FINITE ELEMENT METHOD

Residual Stress Modeling of Narrow Gap Welded Joint of Aluminum Alloy by Cold Metal Transferring Procedure

Finite Element Analysis of Modeling Residual Stress Distribution in All-position Duplex Stainless Steel Welded Pipe