Abstract:The secondary modulation with the NeumannHoffman code increases the possibility of bit sign transition. Unlike other GNSS signals, there is no pilot component for synchronization in BeiDou B1/B3 signals, which increases the complexity in acquisition. A previous study has shown that the delay and multiplication (DAM) method is able to eliminate the bit sign transition problem, but it only applies to pretty strong signals. In this paper, a DAM-based BeiDou signal acquisition approach, called variable length data accumulation (VLDA), is proposed to acquire weak satellite signals. Firstly, the performance of DAM method versus the different delays is analyzed. The DAM operation not only eliminates bit sign transition, but it also increases noise power. Secondly, long-term signal is periodically accumulated to improve signal intensity in order to acquire weak signals. While considering the Doppler frequency shift of ranging codes, the signal length must be compensated before accumulating long-term signal. Finally, the fast-Fourier-transform based parallel code phase algorithm are used for acquisition. The simulation results indicate that the proposed VLDA method has better acquisition sensitivity than traditional non-coherent integration method under the same calculation amount. The VLDA method only requires approximately 27.5% of calculations to achieve the same acquisition sensitivity (35 dBHz). What is more, the actual experimental results verify the feasibility of the VLDA method. It can be concluded that the proposed approach is an effective and feasible method for solving the bit sign transition problem.

Code-Doppler-compensation based direct acquisition method for weak GNSS long PN-code

Mapping and Overlapping Based Carrier Frequency Searching Technique for Rapid GNSS Long PN-code Acquisition

An Improved Algorithm Based on Circular Correlation for Fast Acquisition of Spread Spectrum Signals

PN Code Tracking Based on Sub‐nyquist and Non‐commensurate Sampling

Partial-correlation-result Reconstruction Technique for Weak Global Navigation Satellite System Long Pseudo-Noise-code Acquisition

Research on the Effect of Code Doppler on Acquisition Performance and the Compensation Methods

Optimal Regenerative PN Code Tracking Based on Non‐commensurate Sampling and Double‐loop Structure

Modified Pseudo-Noise Code Regeneration Method

Direct GPS P-Code Acquisition Method Based on FFT

Joint Code Acquisition and Doppler Frequency Shift Estimation for Gps Signals

Weak Signal Acquisition of GNSS Based on Code Doppler and Local Clock Skew Compensation

Interleaving of Local Code Replicas-Based Rapid Acquisition Method for Time Division Data Multiplexing Long Pseudo-Noise-Code Signals

GNSS Spoofing Mitigation Based on Joint Detection of Code Doppler and Carrier Doppler in Acquisition

Three-stage based rapid long pn-code acquisition method by employing time-frequency folding technique

Design of acquisition algorithm based on a novel detector for weak GNSS signals

A study of neuman hoffman codes for GNSS application

A BeiDou Signal Acquisition Approach Using Variable Length Data Accumulation based on Signal Delay and Multiplication

A Joint Acquisition Algorithm Based on Primary Code and Secondary Code for Gnss Signals

Direct Acquisition Method of GPS P Code and its Parameter Optimization

A Method for GNSS Spoofing Detection Based on Sequential Probability Ratio Test

Multi Block Overlapping Zero Padding Algorithm for Weak Signal Acquisition.