Theoretical model and numerical study of the effect of target reflected light on high power fiber lasers
Duan Lei,Xun Run-Qin,Song Yun-Bo,Tan Shu-Dan,Liang Cheng-Bin,Xu Fan-Jiang,Liu Zhao-Hui,,
DOI: https://doi.org/10.7498/aps.72.20222464
IF: 0.906
2023-01-01
Acta Physica Sinica
Abstract:In high power fiber laser systems, the reflected light generated when the laser hits the target may be recoupled to the laser and amplified by the laser, thus damaging the laser system. This situation is particularly serious for high power laser systems, such as spectral beam combining of high power fiber lasers, which lack effective light return protection. In order to solve the above problems, it is necessary to integrate various physical effects in the whole system link, evaluate and analyze the influence of reflected light on the operating state of the system, so as to optimize the optical path layout and system structure at the beginning of the design of fiber laser to avoid unnecessary losses. Based on the atmospheric transmission theory, fiber rate equation and medium heat conduction equation model, the effect of reflected light on high power fiber laser is analyzed. This paper is pointing to numerical simulation of coupling efficiency of reflected light of high power fiber lasers. It is found that under certain atmospheric conditions, the reflected power is related to the transmission distance, the offset Angle of the optical axis, divergence angle and the offset of the center position of the beam, and will affect the output power, beam quality factor, thermal effect and the signal to noise ratio of the stimulated Raman scattering spectrum of the fiber laser. The coupling efficiency of reflected light has a maximum value at a certain transmission distance, as an example, reflected light power up to 140W is obtained when transmission distance is 1500m, which will largely affect the laser system. Reflected power is affected by offset Angle of the optical axis far less than transmission distance when transmission increases from 500m to 2000m. As an example, variations of less than 0.1W is obtained when offset Angle increases from 0.11°to 0.44°. It is also shown that as the divergence angle changes from 0 arcsecond to 15 arcseconds, the coupling power decays nearly exponentially with the divergence angle change. The coupling efficiency is close to 1% near 12 arc seconds, which is almost negligible. The output beam quality of the laser system is also affected by the beam quality of reflected light. Deterioration of the beam quality of reflected light will lead to deterioration of the laser output beam quality. When reflected light power enters the fiber laser system increases, the forward output power will decrease and the backward signal power will increase, and the Raman power will increase rapidly near the fiber output end. When the reflected light is present, the thermal effects caused by selecting the gain fiber with different pump absorption coefficients are very important. The SRS rejection ratio decreases with the increase of pump absorption coefficient. As an example, The SRS rejection ratio decreases 5dB when pump absorption coefficient increases from 1.5 dB/m to 4.5 dB /m, resulting in a decrease in the signal-to-noise ratio of the laser, which will decrease the reliability of the fiber laser system. In the design and test of spectral beam combining systems for high power fiber lasers, the attention to reflected light should be paid through the entire process, which includes the outer optical path and the internal optical path of the laser. The comprehensive constraints of multiple key indicators are analyzed, and the probability of system damage or reliability degradation due to reflected light is evaluated. The research results of this paper have certain guiding significance for selecting suitable outer optical path layout and system parameters and optimizing the design of high energy fiber laser system.
physics, multidisciplinary