Abstract:As the cross-correlation peak between the GPS C/A codes is non-zero, it will degrade the performance of the detection probability and increase the bit error rate of the weak signals when coexisting strong ones. In this paper, the basic principle of the cross-correlation mitigation method based on subspace projection is analyzed and the architecture of suppressor is presented. The corresponding subspace matrix for strong signals can be constructed after the receiver acquiring the code phases, carrier frequencies and data-bit modulation of all strong signals. The projection of the input signals onto the strong signal subspace is the sum of the strong signals and the projection of the noise. Then the projection can be used as an estimate of the strong signals. After subtracting the estimated strong signals from the input signals, the result consists of weak signals, noises and the residue error resulted from the projection operation. Then the acquisition and tracking of the weak signals can be implemented. Two kinds of receiver structure have been proposed for two different scenarios. One is for that the strengths of the strong signals are almost the same. And the other is under that the strengths of the strong signals are largely different.In comparison with the direct interference cancellation technique, only the code phases, carrier frequencies and data-bit modulation of strong signals are required and the method is independent of the carrier phases of the strong signals with complex signal processing. The simulation results indicate that the method can suppress the cross-correlation interference effectively and ADC requires 4-bit quantization at least when the weak signal to the strong signal ratio is -20 dB.

A Gaussian Code Phase Discriminator for GPS/INS Tracking Loop under Multi-Path Interference

Simple Approach to Determining Parameters of Noncommensurate Sampling for Optimal Pseudo-Noise Code Phase Delay Discrimination

A Subspace-Based Code Tracking Loop Design for GPS Multi-Antenna Receiver in Multipath Environment

Code Phase Interleaving Method for GPS Signal Acquisition

General Design Methodology of Code Multi‐correlator Discriminator for GNSS Multi‐path Mitigation

Dual Update-Rate Carrier Tracking Technique for New Generation Global Navigation Satellite System Signals in Dynamic Environments

High-Accuracy Absolute-Position-Aided Code Phase Tracking Based on RTK/INS Deep Integration in Challenging Static Scenarios

Performance and Evaluation of GNSS Receiver Vector Tracking Loop Based on Adaptive Cascade Filter

Joint Code Acquisition and Doppler Frequency Shift Estimation for Gps Signals

Low-Complexity Code Tracking Loop with Multipath Diversity for Gnss over Multipath Fading Channels

A Novel Method of Multipath Mitigation for PN Code Tracking Loop Based on Wavelet Transform

Performance Analysis of Global Navigation Satellite System Signal Acquisition Aided by Different Grade Inertial Navigation System under Highly Dynamic Conditions

A tracking method for GPS L2C signal based on the joint using of data and pilot channels

Performance Analysis Of Deeply Coupled Ins Assisted Multi-Carrier Vector Phase Lock Loop For High Dynamics

A GPS Phase-Locked Loop Performance Metric Based on the Phase Discriminator Output

FFT Tracking Based High Dynamic GPS/INS Scalar Deeply Integrated Navigation Algorithm

Distortionless pseudo‐code tracking space–time adaptive processor based on the PI criterion for GNSS receiver

Dual-Update Rate Ins Aided Carrier Phase Lock Loop For New Generation Global Navigation Satellite Signals

A new coarse-time GPS positioning algorithm using combined Doppler and code-phase measurements

Tracking Method Based on Multi-Carrier-Loops for GPS Signal under High Dynamic Conditions

A Cross-Correlation Mitigation Method Based on Subspace Projection for Gps Receiver