The mechanism of adsorption and a new method to reduce surfactant loss in chemical flooding
C YANG,W JAO,Y HUANG
DOI: https://doi.org/10.1016/0920-4105(89)90036-3
IF: 5.168
1989-01-01
Journal of Petroleum Science and Engineering
Abstract:The effectiveness of surfactant-polymer flooding depends largely on the stability of its formulation. After coming into contact with reservoir rocks, the carefully screened optimal surfactant displacement system will lose its low interracial tension and high solubilization, because of a change in the compatibility formulations and a significant decrease of surfactant concentration. There are many reasons for the loss of surfactant concentration; at present, surfactant adsorption on the mineral surfaces of the rock has been most discussed (Boneau, 1977; Hanna and Somasundaran, 1977, 1979; Lawson, 1978; Zapak, 1980; Kalpakci et al., 1981; Clementz, 1982). To obtain a clear idea of the adsorption behavior of an anionic surfactant sodium alkyl benzene sulfonate (SDDBS; widely used in the formulation of a displacement reagent) it is necessary to study its adsorption on various minerals, i.e., quartz and clay (montmorillonite, kaolinite, illite, etc.), which are the main components of the reservoir rocks, and on carbonates. Wayman (1963) studied the adsorption of a dilute solution of SDDBS on various clays, and Scamehorn (1980) investigated the adsorption of alkyl benzene sulfonate homologous aqueous solutions on kaolinite, A1203. These workers indicated that the adsorption isotherms conform with the Langmuir equation and can be described by the Truber diagram. On the other hand, Meader (1952), Hanna and Somasundaran (1977,1979), Somasundaran (1980), and Trogus (1979), studied the adsorption of sodium alkyl benzene sulfonate on bioglass, kaolin, and Berea sand core, and pointed out that the adsorption isotherms do not conform with the Langmuir equation: a maximum adsorption value was observed, sometimes followed by a minimum value. There are various explanations for this type of adsorption isotherm, and experimental results on the influence of the selective wetting of a mineral surface on adsorption are also quite varied. Zapah (1980) and Kalpokei et al. (1981) pointed out that adsorption on an oil-wet surface is less than that on a water-wet surface. However, the results of Boneau (1977) are contrary to this. According to his investigation, Clementz (1982) indicated that adsorption of pure SDDBS (recrystallized) on organo-montmorillonite is less than that on montmorillonite, whereas commercial SDDBS (with a purity of less than 60%) has identical results when the concentration of SDDBS solutions is less than their critical micellar concentration. However, the results were