Abstract:The responses of the surface structures to the solvent vapor treatment for the films of styrene(S)/ isoprene(I)/styrene(S) tri-block copolymers (SIS) prepared by various casting solvents and film-formation methods (solvent-casting and spin-coating) were investigated by contact angle measurement, atomic force microscopy (AFM) and sum frequency generation vibrational spectroscopy (SFG). It was shown that the surface wettability of the SIS solvent-cast films (cyclohexanone as solvent) and spin-coated films (toluene as solvent) exhibited the reversibly switching properties, if alternately exposed them to the vapor of PI-selective (cyclohexane) and PS-selective (butanone) solvents. However, for the solvent-cast films prepared by cyclohexane and toluene solution, the wettability of the films surface did not change, regardless of which solvent was applied in vapor treatment. It was claimed that the difference in the phase-separation structure of the SIS films prepared using different casting solvents and film-formation methods is the main reason for the discrepancy in the surface adaptive behavior. If the films have the equilibrium phase structures, the energy barrier for the conformation adjustment is apparently larger, and therefore it is hard to change the aggregation structure to accommodate the new solvent-vapor environment. While for the films having the non-equilibrium phase-separation structures, the conformational adjustment under the different solvent vapor will become relatively easier. Owing to this effect, the prepared SIS films with various film-formations kinetics can form different aggregation structures after a specific solvent vapor treatment, and finally leads to dissimilar surface structure. As a result, the surface wettability of these films exhibit different responsiveness to solvent vapor.

EFFECT OF SOLVENTS ON PREPARING SURFACE-MACROPOROUS POLYSTYRENE

Synthesis Of Cationic Surface Sizing Agent And Its Application

Preparation of monodisperse polystyrene particles and assembly of spherical colloidal crystals

Preparation and Structure of Polystyrene/Montmorillonite Nanocomposite

Fabrication of Polystyrene Substrate with Porous in Limited Region on the Surface

Synthesis and Characterization of Polystyrene-G-polydimethylsiloxane Copolymers

Solvent Effect on the Surface Morphology of Polymer Blend Thin Films During Spin-coating Process

Study on Preparation of Polystyrene Micro-particles by Solventing-out Process

The Influencing Factors on the Macroporous Formation in Polymer Films by Water Droplet Templating

Preparation of Polystyrene/Sio2 Composite Nanoparticles Bearing Sulfonic Groups on the Surface Via Emulsion Copolymerization Using A Polymerizable Emulsifier

Evaporative deposition of polystyrene microparticles on PDMS surface

Surface Modification of Polystyrene Latex Particles Via Atom Transfer Radical Polymerization

Interface Morphology of Polystyrene-g-Polysiloxane Regular Graft Copolymers

THE SYNTHESIS AND SURFACE CHARACTERIZATION OF AMPHIPHILIC GRAFT COPOLYMER PS-g-NPEO ——THE INFLUENCE OF SOLVENT AND SOLUTION CONCENTRATION

PREPARATION OF MONODISPERSE CROSS-LINKED POLYSTYRENE MICROSPHERES BY COMBINING DISPERSION POLYMERIZATION WITH HYDROTHERMAL PROCESS

Environmental Adaptivity of the Surface of Styrene-Isoprene-styrene Tri-Block Copolymers Films Controlled by the Film-Preparation Kinetics

Synthesis and Surface Properties of Polystyrene‐graft‐poly(ethylene Glycol) Copolymers

Influence of the solvent removal method on the morphology of polystyrene porous structures prepared via thermally induced phase separation

Surface properties and cell-surface interaction of polystyrene- graft -poly(2-hydroxyethyl methacrylate)

Novel Approach to Synthesis of Monodisperse Polymeric Microspheres: Heterophase Polymerization of Styrene and Methyl Methacrylate in Presence of Water-Insoluble Functional PDMSs

A Simple and Environment-Friendly Approach for Synthesizing Macroporous Polymers from Aqueous Foams