Abstract:The dynamic behavior of a sucker rod string is usually governed by a wave equation, which is used for a sucker rod pumping system design or diagnosing downhole working conditions. The wave equation is deduced by analyzing the force and moment applied on the rod string. Buoyancy is one of the forces distributed along the rod string in deviated wells and coupled with side force between the rod string and the tubing. Buoyancy also affects the downhole load of the subsurface pump. However, there is little knowledge concerning how buoyancy affects the dynamic behavior of the sucker rod string.In this paper, three buoyancy handling methods are analyzed. These methods include the conventionally used buoyancy factor method (BFM), and the end force method (EFM) which ignores the fluid force on the cylindrical surface of the rod string. A new direct calculation method (DCM) that directly calculates the fluid force acting on the curved cylindrical surface of the rod element is presented. The wave equations using three different buoyancy handling methods are deduced, and their different subsurface dynamometer cards as boundary conditions are discussed. The solutions for three different wave equations are either analytically or numerically compared. The results indicate that the solutions of BFM and DCM are equivalent and differ by a fictitious term. The solutions of DCM and EFM have subtle distinction due to relative small distributed fluid force on the cylindrical surface. This study characterizes the effect of buoyancy, as well as supporting the unproved reasonableness of BFM and EFM on the sucker rod string dynamics. The presented DCM can also contribute to more precise prediction or diagnosis of downhole working conditions. (C) 2016 Elsevier B.V. All rights reserved.

Experimental Study on the Second-Order Buoyancy of Magnetic Fluid

A Novel Method for Calculating and Measuring the Second-Order Buoyancy Experienced by a Magnet Immersed in Magnetic Fluid

Effective and Practical Methods to Calculate the Second-Order Buoyancy in Magnetic Fluid Acceleration Sensor

Study on second-order buoyancy segment linearity in magnetic liquids

Research Progress of Magnetic Fluids

Numerical Simulation and Experimental Study on the Ferrofluid Second-Order Buoyancy with a Free Surface

Theoretical and Experimental Research on the Ferrofluid Second-Order Buoyancy with a Free Surface

The Experimental Study of the Magnetic Fluid Damper Based on the Principle of Second-Order Buoyancy

Application of the magnetic fluid in viscosity drag reduction

Application and Effect of Buoyancy on Sucker Rod String Dynamics

Study on magnetic liquids properties for sensor design

Experimental Research on Tilt Measurement Sensor Based Magnetic Fluid

Research on the Self-Levitation of Cylindrical Magnets with Wrapped Shells in Magnetic Fluid: Consideration Magnetization Direction of Magnets

Effects of magnetic fluid on magnetic fluid damper

Study of the Second-Order Levitation Force in the Magnetic Fluid Accelerometer

Numerical Analysis and Experiment Study of Magnetic Fluid Boundary in Seals

Boundary interface condition of magnetic fluid determines the magnetic levitation force experienced by a permanent magnet suspended in the magnetic fluid

Research on the magnetic fluid levitation force received by a permanent magnet suspended in magnetic fluid: Consideration a surface instability

Experimental Error Analysis of Measuring the Magnetic Self-Levitation Force Experienced by a Permanent Magnet Suspended in Magnetic Fluid with a Nonmagnetic Rod

Research on the Density of Magnetic Fluid and its Application in Mineral Separation

Numerical Analysis of Magnetically Induced Free Convection in Air