Abstract:The development of one-part geopolymer mortars has greater potential than the traditional two-part mortars, especially in repair applications, to convert waste into useful beneficial products while simultaneously eliminating the hazards associated with the alkaline solutions. Nevertheless, the inherent brittleness exhibited by the one-part geopolymers displays drawbacks like OPC when subjected to flexural loading. The fibers selection as well as their strengthening effects from literature is considerably scarce, especially for the repairing geopolymer system. This work aims to investigate the influences of fiber types and volume fractions on the workability, physical behavior, and cracking/fatigue resistance of ambient air-cured one-part geopolymer mortar. Reaction kinetics, mineralogical phases, and elemental components were explored by means of the TAM, quantitative XRD, and EDS mapping analysis. The FESEM and X-CT were employed to compare the microstructures and pore characteristics of the fibers-reinforced products. The results show that the copper-plated steel fiber produced the least change in workability, while the basalt fiber produced the lowest flow values. Setting time was the shortest for the basalt fiber reinforced, followed by polyvinyl-alcohol fiber. The steel fiber and carbon fiber would improve the mechanical properties of mortar significantly, especially in the early stage. The fatigue strength of 1 vol% carbon fiber reinforced mortar under 2 million cycles loading was the highest (3.72 MPa). The fibers addition a substantial decrease in sphericity and compactness of the pores (high anisotropy) as evidenced by X-CT data. Moreover, three hydration heat processes occurred after water was added to the one-part geopolymer mortar, which included dissolution of Na2SiO3 particles, network degradation, and a second pozzolanic reaction. More crystalline formation occurred over curing time to form gel networks with high stability and generated different bonding modes with various fibers.

Polymer Modification Technology of Expanded Perlite and Polymer Thermal Insulation Mortar

Characteristic of thermal insulation polymer mortar

Development and application of inorganic-organic compound thermal insulating mortar

Effect of waterproof agent on performance of inorganic lightweight aggregate thermal insulating mortar

Preparation of EPS-Based Thermal Insulation Mortar with Improved Thermal and Mechanical Properties

Mechanical Characterization of Polyacrylate Emulsion Modified Mortars

High Performance and Low Cost Compound Admixture of Expanded Perlite Powder/Redispersible Polymer Powder for Dry-Mixed Mortar

Development of Asphalt Emulsion-Polystyrene Grain Thermal Insulation Mortars

Performance Characteristics of Micro Fiber-Reinforced Ambient Cured One-Part Geopolymer Mortar for Repairing

MODIFICATION ANALYSIS AND EXPERIMENTAL STUDY OF MOSONRY MORTAR

Effects of Asphalt Emulsion Addition on the Performance of Polystyrene Grain Thermal Insulation Mortars

Physical and Chemical Influence of Polyacrylate Latex on Cement Mortars

Investigation of Physical-Mechanical Properties and Microstructure of Mortars with Perlite and Thermal-Treated Materials

Mechanical properties and microscopic characterization of waste perlite powder as supplementary cementitious material

Organic and Inorganic Reactions in Polyacrylate Modified Cement Mortars

Research on the Microstructure Formation of Polyacrylate Latex Modified Mortars

Experimental Studies on the Properties of EPS Thermal Insulating Mortar

Research on Interfacial Bonding Properties and Engineering Applications of Polymer Modified Mortar

Polymer-modified cement mortars: Their enhanced properties, applications, prospects, and challenges

Improving the thermal and mechanical performance of cement-based mortars for reinforcing masonry structures: computational and experimental methods

A Novel Inorganic Thermal Insulation Material Utilizing Perlite Tailings