Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

A STUDY OF THE RELATION BETWEEN THE RELATIVE BONDED AREA AND THE FIBER FLEXIBILITY (Ⅱ)

Mechanical Properties of SFRC: Database Construction and Model Prediction

Chemical Treatment of Carbon Fibers and the Development of Functional Paper

Measurement and Evaluation of Fiber Bundle Surface of Long Fiber Reinforced Woven Composites

A Statistical Model To Evaluate Fiber Bending Flexibility

Full-field, quasi-3D hygroscopic characterization of paper inter-fiber bonds

Investigation On Flexural Behavior Of Reinforced Concrete Beams Flexurally Strengthened By Different Methods

Role of inter-fibre bonds and their influence on sheet scale behaviour of paper fibre networks

Fiber Bending Flexibility Evaluation by Worm-like Chain Model

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

FUNDAMENTAL STUDY ON BOND MECHANISM OF CARBON FIBER SHEET

Influence of fiber composition and drying conditions on the bending stiffness of paper

Studies Upon the Structure and Properties of Cotton/Wood Pulp Blends Cellulose Acetate Fiber

Influence of density and chemical additives on paper mechanical properties

Estimation of the in-situ elastic constants of wood pulp fibers in freely dried paper via AFM experiments

Study on the Suitability of Bamboo Fiber for Manufacturing Insulating Presspaper

An Improved Method for Single Fiber Tensile Test of Natural Fibers

Humidity Influence on Mechanics and Failure of Paper Materials: Joint Numerical and Experimental Study on Fiber and Fiber Network Scale

AFM-based low frequency viscoelastic characterization of wood pulp fibers at different relative humidity

Modeling the flexural rigidity of spunlace nonwoven fabrics