Abstract:Terrain Awareness and Warning Systems (TAWS) are on-board systems that alert crews to imminent Controlled Flight into Terrain (CFIT). Originally required by the FAA in 1974 for all Part 121 aircraft, this technology has advanced to include GPS data, terrain and obstacle databases, and sophisticated flight deck displays to provide increasingly accurate and timely alerts. TAWS equipment is capable of generating a set of audible and visual alerts based on the most likely situations which lead to a high risk of CFIT. These include excessive descent rates, excessive vertical deviation from an Instrument Landing System (ILS) glideslope, proximity to terrain with landing gears up, and descent immediately following a takeoff. Although the incident rate of CFIT has been greatly reduced over the past few decades, areas of risk still exist, typically near small airports surrounded by mountainous terrain. Risk also remains due to economic factors. The high cost of hardware and software upgrades delays the universal adoption of the most advanced TAWS equipment. Older equipment is much more likely to generate nuisance alerts-warnings to the crew during periods of low CFIT risk. These nuisance alerts desensitize crews to TAWS, leading to situations where crews may ignore or not fully respond to alerts that indicate real danger. Separately, FAA NextGen efforts are driving major redesigns of airspaces and procedures across the country. The primary factors in redesign focus on minimizing the costs associated with delay and fuel burn; however, these redesigns must also ensure that changes do not introduce new CFIT risks. Current practices depend on incomplete evidence to determine that risk has not increased. The continued elimination of remaining CFIT risk, along with the possibility of introducing new risk during redesign, necessitate a comprehensive TAWS model to understand current and potential hazards. Without a TAWS model to provide rapid feedback during simulated design changes, several months may pass before observing that a design change has increased CFIT risk. In this paper, we describe the construction and validation of a standards-based TAWS model to capture the behavior of a variety of equipment. This paper also describes a process for measuring the effect of procedure redesign on TAWS alert rates. Finally, we include a case study of analyzing approaches into the airport at Eagle, CO—the airport with the highest TAWS alert rates in the country. In this case study, we find that equipment upgrades would eliminate nuisance alerts for aircraft using currently published approach procedures.

A Simulation and Verification Platform for Low-Level Windshear Warning Function of TAWS

Simulation and Study of Windshear Signal in Airborne Pulse Doppler Weather Radar

A Simulation and Verification Platform for Avionics Systems Based on Future Airborne Capability Environment Architecture

Digital Simulation of Aircraft Environment Surveillance System

Forward Looking Function of TAWS in Civil Aircrafts and the Simulation Realization

Data Generator Techniques of TAWS Test System Flight Simulation

Application and development of weather radar predicting windshear function in civil aviation

Study on Mode 3 Alert Envelope of Terrain Awareness and Warning System

Three-dimensional visual simulation of civil aircraft taking off in wind shear

Research on RTW and VxWorks based simulation experiment platform for flight control system

Study on the Influence of Topography on Wind Shear-Numerical Simulation Based on WRF-CALMET

A New Method for Detecting and Simulating Turbulence Signals of Airborne Weather Radar

Wind Shear Operation-Based Competency Assessment Model for Civil Aviation Pilots

Modeling terrain awareness and warning systems for airspace and procedure design

A Stateflow Based Simulation Of Uav Multi-Mode Flight Control

Design and Verification of Simulation Platform for Aircraft Engine Sensor Fault Diagnosis

Analysis and simulation of an airborne weather radar

Identification and analysis of terrain-induced low-level windshear at Hong Kong International Airport based on WRF–LES combining method

A FACE-based Simulation and Verification Approach for Avionics Systems

Modular aircraft simulation platform based on simulink

Numerical Simulation for Wind Shear Detection With a Glide Path Scanning Algorithm Based on Wind LiDAR