Abstract:Polymer and small molecules are often used to modify the wettability of mineral surfaces which facilitates the separation of valuable minerals such as molybdenum disulfide (MoS2) from gangue material through the process of froth flotation. By design, traditional methods used in the field for evaluating the separation efficacy of these additives fail to give proper access to adsorption kinetics and molecule conformation, crucial aspects of flotation where contact times may not allow for full thermodynamic equilibrium. Thus, there is a need for alternative methods for evaluating additives that accurately capture these features during the adsorption of additives at the solid/liquid interface. Here, we present a novel method for preparing MoS2 films on quartz crystals used for Quartz Crystal Microbalance with Dissipation (QCM-D) measurements through an electrochemical deposition process. The resulting films exhibit well-controlled structure, composition, and thickness and therefore are ideal for quantifying polymer adsorption. After deposition, the sensors can be annealed without damaging the quartz crystal, resulting in a phase transition of the MoS2 from the as-deposited, amorphous phase to the 2H semiconducting phase. Furthermore, we demonstrate the application of these sensors to study the interactions of additives at the solid/liquid interface by investigating the adsorption of a model polymer, dextran, onto both the amorphous and crystalline MoS2 surfaces. We find that the adsorption rate of dextran onto the amorphous surface is approximately twice as fast as the adsorption onto the annealed surface. These studies demonstrate the ability to gain insight into the short-term kinetics of interaction between molecules and mineral surface, behavior that is key to designing additives with superior separation efficiency.

Entropic Depletion Effect on Supermolecular Assembly: Control of Geometry of Adsorbed Molecules in Coatings

Depletion effect on supermolecular assembly: A control of geometry of adsorbed molecules

Control of the Geometry of the Adsorbed Thin Layer by the Depletion Interaction

Entropic Interactions in Semiflexible Polymer Nanocomposite Melts

Selective adsorption behavior of polymer at the polymer–nanoparticle interface

Aggregation of Organic Molecules on Silver Surface with the Balance Between Molecule–substrate Interaction and Intermolecular Interaction

Depletion-Induced Self-Assembly of Colloidal Particles on a Solid Substrate

Theoretical and Experimental Adsorption Studies of Polyelectrolytes on an Oppositely Charged Surface

Exploring the Adsorption Mechanism of Tetracene on Ag(110) by STM and Dispersion-Corrected DFT

Using Depletion to Control Colloidal Crystal Assemblies of Hard Cuboctahedra

Electrochemically deposited molybdenum disulfide surfaces enable polymer adsorption studies using quartz crystal microbalance with dissipation monitoring (QCM-D)

Theoretical Study of Comb-Polymers Adsorption on Solid Surfaces

Deposition and Adhesion of Polydopamine on the Surfaces of Varying Wettability.

Simultaneous depletion and adsorption in polymer solutions near a solid wall

Depletion driven adsorption of colloidal rods onto a hard wall

Controllable Assembly of Colloid Particles on the Surface of Polyelectrolyte Multilayer Films

Revealing the Physico-Chemical Basis of Organic Solid-Solid Wetting Deposition: Casimir-Like Forces, Hydrophobic Collapse, and the Role of the Zeta Potential

Interfacial Engineering of Soft Matter Substrates by Solid-State Polymer Adsorption

Polymers near Metal Surfaces: Selective Adsorption and Global Conformations

A Computer Simulation Study on Deposition Patterns of Cyclic Diblock Copolymer Solution Nanodroplets: Influence of Polymer Length and Concentration

Influence of molecular architecture on the dewetting of thin polystyrene films