Abstract:Atomization spray of non-Newtonian liquid plays a pivotal role in various engineering applications, especially for the energy utilization. To operate spray systems efficiently and well understand the effects of liquid rheological properties on the whole spray process, a comprehensive model using Euler-Lagrangian approaches was established to simulate the evolution of the atomization spray for viscoelastic liquid. Based on the Oldroyd model, the viscoelastic linear dispersion relation was introduced into the primary atomization; an extended viscoelastic version of Taylor analogy breakup (TAB) model was proposed; and the coalescence criteria was modified by rheological parameters, such as the relaxation time, the retardation time and the zero shear viscosity. The predicted results are validated with experimental data varying air-liquid mass flow ratio (ALR). Then, numerical calculations are conducted to investigate the characteristics of viscoelastic liquid atomization process. Results showed that the evolutionary trend of droplet mean diameter, Weber number and Ohnesorge number of viscoelastic liquids along with axial direction were qualitatively similar to that of Newtonian liquid. However, the mean size of polymer solution increased more gently than that of water at the downstream of the spray, which was beneficial to stable control of the desirable size in the applications. As concerned the effects of liquid physical properties, the surface tension played an important role in the primary atomization, which indicated the benefit of selecting the solvents with lower surface tension for finer atomization effects, while, for the evolution of atomization spray, larger relaxation time and zero shear viscosity increased droplet Sauter mean diameter (SMD) significantly. The zero shear viscosity was effective throughout the jet region, while the effect of relaxation time became weaken at the downstream of the spray field.

The Drop Oscillation Model and the Comparison with the Numerical Simulations

A numerical analysis of drop impact on solid surfaces by using smoothed particle hydrodynamics method

Modeling of Early Stage Droplet Spreading Based on Numerical Simulations

Numerical Simulation of a Single Drop Impact on Liquid Surface using Particle Method

Droplet Oscillation After Impact On A Solid Surface

Numerical study of natural oscillations of supported drops with free and pinned contact lines

Breakup Model of Oscillating Drops in Turbulent Flow Field

SPH Modeling of Multiphase Drop Dynamics

Numerical Investigations of Collision Modes of Double Droplets on a Spherical Surface Based on the Phase Field Method

Numerical Models For Viscoelastic Liquid Atomization Spray

Numerical Study of Drop Interface Deformation and Breakup in Shear Flow

Simulation and modeling of the vaporization of a freely moving and deforming drop at low to moderate Weber numbers

Numerical Investigations of the Spreading and Retraction Dynamics of Viscous Droplets Impact on Solid Surfaces

A model to predict the oscillation frequency for drops pinned on a vertical planar surface

Simulation of dynamic characteristics of droplet impact on liquid film

Improvement of Surface Tension Model and Numerical Investigation on Droplet Wetting Effect

Numerical Simulation of Drops Falling to and Splashing on Liquid Interfaces

Bouncing Dynamics of Drops' Successive Off-Center Impact

Simulation and analytical modeling of high-speed droplet impact onto a surface

Dynamics of Drop Impact Onto a Solid Sphere: Spreading and Retraction

Analytical Consideration For The Maximum Spreading Factor Of Liquid Droplet Impact On A Smooth Solid Surface