Heat-flux Enhancement by Vapour-Bubble Nucleation in Rayleigh–Bénard Turbulence
Daniela Narezo Guzman,Yanbo Xie,Songyue Chen,David Fernandez Rivas,Chao Sun,Detlef Lohse,Guenter Ahlers
DOI: https://doi.org/10.1017/jfm.2015.701
IF: 3.7
2015-01-01
Journal of Fluid Mechanics
Abstract:We report on the enhancement of turbulent convective heat transport due to vapour-bubble nucleation at the bottom plate of a cylindrical Rayleigh–Bénard sample (aspect ratio 1.00, diameter 8.8 cm) filled with liquid. Microcavities acted as nucleation sites, allowing for well-controlled bubble nucleation. Only the central part of the bottom plate with a triangular array of microcavities (etched over an area with diameter of 2.5 cm) was heated. We studied the influence of the cavity density and of the superheat $T_{b}-T_{on}$ ( $T_{b}$ is the bottom-plate temperature and $T_{on}$ is the value of $T_{b}$ below which no nucleation occurred). The effective thermal conductivity, as expressed by the Nusselt number $\mathit{Nu}$ , was measured as a function of the superheat by varying $T_{b}$ and keeping a fixed difference $T_{b}-T_{t}\simeq 16$ K ( $T_{t}$ is the top-plate temperature). Initially $T_{b}$ was much larger than $T_{on}$ (large superheat), and the cavities vigorously nucleated vapour bubbles, resulting in two-phase flow. Reducing $T_{b}$ in steps until it was below $T_{on}$ resulted in cavity deactivation, i.e. in one-phase flow. Once all cavities were inactive, $T_{b}$ was increased again, but they did not reactivate. This led to one-phase flow for positive superheat. The heat transport of both one- and two-phase flow under nominally the same thermal forcing and degree of superheat was measured. The Nusselt number of the two-phase flow was enhanced relative to the one-phase system by an amount that increased with increasing $T_{b}$ . Varying the cavity density (69, 32, 3.2, 1.2 and $0.3~\text{mm}^{-2}$ ) had only a small effect on the global $\mathit{Nu}$ enhancement; it was found that $\mathit{Nu}$ per active site decreased as the cavity density increased. The heat-flux enhancement of an isolated nucleating site was found to be limited by the rate at which the cavity could generate bubbles. Local bulk temperatures of one- and two-phase flows were measured at two positions along the vertical centreline. Bubbles increased the liquid temperature (compared to one-phase flow) as they rose. The increase was correlated with the heat-flux enhancement. The temperature fluctuations, as well as local thermal gradients, were reduced (relative to one-phase flow) by the vapour bubbles. Blocking the large-scale circulation around the nucleating area, as well as increasing the effective buoyancy of the two-phase flow by thermally isolating the liquid column above the heated area, increased the heat-flux enhancement.