Abstract:Traditional frequency-domain dynamic analysis methods can only compute the steady-state responses of the system, typically by employing the fast Fourier transform (FFT). In this paper, a new frequency-domain method that can consider the initial conditions is proposed. External loadings are decomposed into Prony series, and the initial conditions are transferred from the system into the reconstructed loadings, which are combinations of the initial loadings and the corresponding initial conditions in the Laplace domain. Similar to the traditional frequency-domain method, the inverse Fourier transform (IFT) is used to compute the responses of the system in the time domain. One theoretical development is that the initial conditions can be combined into the corresponding reconstructed loadings, which avoids the required periodic assumption for the FFT. The other improvement is that the decomposition of the initial external loadings requires only a short duration of measurements, which indicates a good potential capability of the computing efficiency for complex systems. The numerical results from a single degree-of-freedom (DOF) indicate that the proposed method can perform similar to the frequency-domain method if only the initial conditions are set to zero values because the IFT is used. When non-zero initial conditions are considered, the proposed method has a similar accuracy to the time-domain method, but one should note that the proposed method has an error on the response at time zero. One can draw identical conclusions from the numerical results of a four-DOF system, which demonstrates the ability to address multiple-DOF systems. The third example is a three-dimensional (3D) frame structure subjected to more general external loadings by randomly generating different components; the initial conditions are simulated using two series of random numbers: one is for the initial displacements and the other is for the initial velocities. The results show that the proposed method obtains consistent responses with the time-domain method, but it has better computation cost because the equations of motion are solved in the frequency domain. In addition, the reason and corresponding measurement on most relative errors at the early time are also provided.

An improved algorithm for random loading identification and experimental validation

An improved method of structural random loading identification

Experimental Study of a Multipoint Random Dynamic Loading Identification Method Based on Weighted Average Technique

Experimental Study of Random Dynamic Loads Identification Based on Weighted Regularization Method

Fast Identification of Random Loads Using the Transmissibility of Power Spectral Density and Improved Adaptive Multiplicative Regularization

Novel load identification method based on the combination of Tikhonov regularization and singular value decomposition

Computer Simulation of Optimal Sensor Locations in Loading Identification

Load Identification with Regularized Total Least-Squares Method

A Uncorrelated Multi-Sources Dynamic Random Load Identification Algorithm Based on Least-Squares in Frequency

An Optimization Method of Load Identification in Frequency Domain

Experiment Study of Structural Random Loading Identification by the Inverse Pseudo Excitation Method

Random Dynamic Load Identification Based on Error Analysis and Weighted Total Least Squares Method

An improved algorithm for stochastic load identification for random system

Prediction of Random Dynamic Loads Using Second-Order Blind Source Identification Algorithm

Dynamic load localization using the quasi-frequency response function

A novel time-domain dynamic load identification numerical algorithm for continuous systems

Application of the Random Decrement Technique in Damage Detection under Moving Load

A new method of load identification in time domain

Initial-condition consideration by transferring and loading reconstruction for the dynamic analysis of linear structures in the frequency domain

Application of Generalized Epsilon Decomposition Method in Loading identification

A Non-Iterative Method for Dynamic Load Identification